RI GS 300/Aristo Garage Sale
10-01-09, 11:27 AM
#16
Pole Position
iTrader: (1)
Join Date: Feb 2006
Location: florida
Posts: 326
Likes: 0
Received 0 Likes
on
0 Posts
do you have the black trim piece that goes in front of the lower part of the gauge cluster?.it the piece that has the traction control switch and the dimmer switch.
12-10-09, 10:51 AM
#30
Driver School Candidate
Join Date: Sep 2003
Location: International
Posts: 41
Likes: 0
Received 0 Likes
on
0 Posts
Don't know if you have them, but if this is a pre '98 clip, are the front lower rear control/caster arms available?
FYI - the bushing ID on the arm is uniform at approx .630" whereas the 98 up arm, although identical in appearance otherwise, uses a stepped bushing ID of .750" at the top and .560" at the bottom. The pre 98 bolts won't fit post 98 bushings and I assume that they also won't fit through the upper hole on the subframe in case you were thinking about boring out the bushing sleeve and then putting a spacer sleeve at the top to keep the bolt concentric in the sleeve, which is one idea I dismissed.
FYI - the bushing ID on the arm is uniform at approx .630" whereas the 98 up arm, although identical in appearance otherwise, uses a stepped bushing ID of .750" at the top and .560" at the bottom. The pre 98 bolts won't fit post 98 bushings and I assume that they also won't fit through the upper hole on the subframe in case you were thinking about boring out the bushing sleeve and then putting a spacer sleeve at the top to keep the bolt concentric in the sleeve, which is one idea I dismissed.
Last edited by Adrenaline; 12-10-09 at 10:59 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Glack32
2Gen GS430 / 400/ 300 Classifieds (98-05)
4
06-28-14 07:43 PM
