white_is

iTrader: (4)

*** would people be more interested if I had this stuff powder coated? ***
I can have it done... Just PM me...

Prices are OBO!!
Will trade for:
BLACK CLOTH REAR SEATS
Cusco under braces
Wingless spoiler
Front or rear knuckle/hubs.
Front lower control arms. #2 I think
Figs Trac Links or Heat shield.
2002+ Mirrors, broken or working, MUST have plugs!


Prices do not include shipping.

Y Piece: $30
Upper Intake Plenum: $65
GOOD Valve Covers: $65
"Bad" Valve Covers: $40
Motor Mount: $12 SHIPPED for both.
Intake canister: $25
Injector: $12each, $65 for all 6
Fuel Rail: $35
Long block: $450


Spare motor parts for sale. Will also sell the complete long block. Will possibly separate for the right price.

All parts are from a 2002 IS that was wrecked. The motor was RUNNING before and after the wreck. Mileage was right around 100,000 miles.



Some of the stuff pictured has been sold. If it's not listed and is an accessory I probably don't have it.






Prices DO NOT include shipping or Paypal fees.
Feel free to make an offer. Prices are listed below.

I have TWO sets of valve covers. I bought one set, and it had a small piece chipped on it. I saved that piece (and it's pictured) but I didn't know if I wanted to use them. Each cover also has one bolt broken off in it.. I went ahead and bought a second set that has NO issues but I don't need any of them now.

Bad - PRICE = $45






Good - PRICE = $70


Intake Canister - PRICE = $30


Motor Mounts - SOLD the thin metal sheet and bracket, just have the mounts themselves left. $15 SHIPPED for both.
Also sold the water pump pulley.



Y Piece - PRICE = $35
Upper Plenum - PRICE = $70




Fuel Rail - PRICE = $40
Fuel Line - PRICE = SOLD
Injectors - PRICE = $12 each, $70 for all 6














I did some looking around, eBay prices are ridiculous. I've seen some pretty good prices around here so I think my pieces will be fairly price considering they will be cleaned up.



PRICES: These do not include shipping or paypal fees.


Y Piece: $30
Upper Intake Plenum: $65
GOOD Valve Covers: $65
"Bad" Valve Covers: $40
Motor Mount: $12 SHIPPED for both.
Intake canister: $25
Injector: $12each, $65 for all 6
Fuel Rail: $35
Long block $450



Feel free to make me an offer. I can do better prices for package deals also. I can also have parts powder coated for good prices too.

white_is

iTrader: (4)

Bump... feel free to send an offer

TLDriver

iTrader: (4)

do you have the crank sensor? the one that goes into the oil pump?

white_is

iTrader: (4)

Yes I should have it. The timing belt/covers are still in place so I haven't dug into the motor yet. If you can wait a little bit I have someone interested in the whole motor. If they don't buy it I'll be starting the tear down.

TLDriver

iTrader: (4)

I can wait, it's going on my go fast build that will take some time anyhow.