WA Intake heat shield and intake pipe with MAF adapter
#1
Intake heat shield and intake pipe with MAF adapter
SRT Intake Heat Shield
Used this with my turbo kit, has roughly a 4" opening and bolts to factory mounting points. Could use to be polished or sanded and painted. There is some residue from epoxy etc...
$65 shipped. Please remember this box for this is rather large.
Steel Intake pipe with aluminum MAF adapter, intake pipe is 3.5" but MAF adapter is for 3", I just sealed the small void left from the mismatched radius with silicon and had no issues. This was the intake for my turbo setup so please be aware that this was routed for a single turbo on a GTE swap, not a stock GS intake. Please make sure your MAF is the correct model for this as well (uses the 98-00 egg style). Could use a sanding and painting/refinishing
$35 shipped
Used this with my turbo kit, has roughly a 4" opening and bolts to factory mounting points. Could use to be polished or sanded and painted. There is some residue from epoxy etc...
$65 shipped. Please remember this box for this is rather large.
Steel Intake pipe with aluminum MAF adapter, intake pipe is 3.5" but MAF adapter is for 3", I just sealed the small void left from the mismatched radius with silicon and had no issues. This was the intake for my turbo setup so please be aware that this was routed for a single turbo on a GTE swap, not a stock GS intake. Please make sure your MAF is the correct model for this as well (uses the 98-00 egg style). Could use a sanding and painting/refinishing
$35 shipped
Thread
Thread Starter
Forum
Replies
Last Post
bzebern
1Gen IS300 Classifieds (98-05)
0
07-03-09 09:40 AM