TX 2jz-ge with a w58 ready to go
07-11-15 | 08:19 PM
#1
Thread Starter
Rookie
Joined: Apr 2013
Posts: 62
Likes: 0
From: ca
2jz-ge with a w58 ready to go
The motor 2jzge from gs300 98
The Ecu
Igniter
W58 with 2jz bell housing from sc300
Shifter
Front driveshaft yoke for the w58
Used clutch
No harness but yes on motor clips
Water hoses
Radiator
Air box with Maf sensor
The motor runs strong
The transmission run greater than ever
I'm located near Houston Texas
Asking 2k obo
The Ecu
Igniter
W58 with 2jz bell housing from sc300
Shifter
Front driveshaft yoke for the w58
Used clutch
No harness but yes on motor clips
Water hoses
Radiator
Air box with Maf sensor
The motor runs strong
The transmission run greater than ever
I'm located near Houston Texas
Asking 2k obo
Last edited by articmonke; 07-11-15 at 08:26 PM.
Trending Topics
07-26-15 | 09:18 AM
#8
Driver School Candidate
Joined: Jul 2015
Posts: 2
Likes: 0
From: nj
i am very curious about how you did the manual conversion. the w58 isnt really strong enough to hold the power i make, but neither is my a650. i would be interested in the manual conversion parts if you would be willing to part. pm me and we can discuss this further or just reply here. thx
07-27-15 | 04:09 AM
#9
Thread Starter
Rookie
Joined: Apr 2013
Posts: 62
Likes: 0
From: ca
i am very curious about how you did the manual conversion. the w58 isnt really strong enough to hold the power i make, but neither is my a650. i would be interested in the manual conversion parts if you would be willing to part. pm me and we can discuss this further or just reply here. thx
Thread
Thread Starter
Forum
Replies
Last Post
trancuongv
SC400 / 300 Classifieds
6
09-04-12 02:05 PM