AZ Custom Kickpanel Speaker Pods
#1
Pole Position
Thread Starter
Join Date: Jul 2006
Location: AZ
Posts: 303
Likes: 0
Received 0 Likes
on
0 Posts
Custom Kickpanel Speaker Pods
I had these custom kickpods fabricated for my IS350 about 18 months ago. They were designed to accomodate an oversized 4" driver, so most 4" drivers should fit. The mounting hole diameter is 3.75" diameter and the flange diameter is 5". The internal volume for the passenger-side pod is .8 cu. liter, the driver's side is slightly larger due to floorpan differences. The black vinyl closely matches the stock black interior, and press-in grilles are included.
These pods are sealed and sit on the carpet, so no custom mods are required to install them (the pods could be modified to vent into the A-frame). They are held in place by internal screws into the sub-carpet pad. The pods may require removal of the E-brake to fit (mine is removed), and the removal of the footrest on the driver side but both of these items can be re-installed later without issue. The floormats will require slight trimming to fit around the pods.
I'm going to an A-pillar configuration next so it's time for these to go. I assume these will also fit ISF and ISC but no guarantee on that.
The condition is very good, no marks on the vinyl and maybe a few light scuffs on the grille rings that can easily be touched up.
Price is $200 OBO shipped, via UPS or USPS to CONUS or APO/FPO addresses only.
These pods are sealed and sit on the carpet, so no custom mods are required to install them (the pods could be modified to vent into the A-frame). They are held in place by internal screws into the sub-carpet pad. The pods may require removal of the E-brake to fit (mine is removed), and the removal of the footrest on the driver side but both of these items can be re-installed later without issue. The floormats will require slight trimming to fit around the pods.
I'm going to an A-pillar configuration next so it's time for these to go. I assume these will also fit ISF and ISC but no guarantee on that.
The condition is very good, no marks on the vinyl and maybe a few light scuffs on the grille rings that can easily be touched up.
Price is $200 OBO shipped, via UPS or USPS to CONUS or APO/FPO addresses only.
Thread
Thread Starter
Forum
Replies
Last Post
MyLparts
Club Lexus Vendor Marketplace
0
01-30-17 09:36 AM
OutlawTita
Lexus Audio, Video, Security & Electronics
4
08-10-05 03:06 PM