CA WTB: ISF Iss Forged Scoops
#2
Lexus Champion
iTrader: (21)
I made one that would works better than theirs. But neither works really. It needs a hood mod to make it work like it was intended to. I had planned to do the hood mod I have in mind & make a thread of it, but probably most wouldnt do it...
ISS scoupe is flat on the bottom & flat on the back with like a 1.5" radius bend in it. So only the air that came in the grill at the very bottom would be directed upward. Mine is like a full radius, so ANY air that comes through the grill, would get directed upward. I think a small section of the bottom of the hood needs an opposite mod to give room & direct the air right into the intake tube. Then it has a great chance of working... I can make you one. Just PM me!
ISS scoupe is flat on the bottom & flat on the back with like a 1.5" radius bend in it. So only the air that came in the grill at the very bottom would be directed upward. Mine is like a full radius, so ANY air that comes through the grill, would get directed upward. I think a small section of the bottom of the hood needs an opposite mod to give room & direct the air right into the intake tube. Then it has a great chance of working... I can make you one. Just PM me!
Last edited by spdrcr771; 11-30-16 at 08:07 AM.
Thread
Thread Starter
Forum
Replies
Last Post
tommigsr
2Gen IS250 / IS350 / IS-F Classifieds (06-13)
1
02-26-14 02:30 PM