DIY; cutting bumper using dremel
#1
Pole Position
Thread Starter
DIY; cutting bumper using dremel
Not sure if this is the right place to post this, but i might attempt to cut my bumper myself using a dremel to make room for bigger exhausts. Does anyone think this is a really bad idea?
It makes sense if im careful and i use to a rubber liner to cover it up at the end. Our bumpers are polyurthene correct? Dont feel like paying a shop 300 dollars to do it for me
all comments and ideas welcome
It makes sense if im careful and i use to a rubber liner to cover it up at the end. Our bumpers are polyurthene correct? Dont feel like paying a shop 300 dollars to do it for me
all comments and ideas welcome
#3
Pole Position
Thread Starter
thanks i relaise that but didnt know where else to post. sides this falls under "mainting the beauty of my lexus" . lol
pls would someone either tell me whats the correct forum is or kindllyanswer the question
pls would someone either tell me whats the correct forum is or kindllyanswer the question
Thread
Thread Starter
Forum
Replies
Last Post