DJ420a's build thread....SC #2
12-24-10, 06:07 PM
#63
Pole Position
Thread Starter
Join Date: Oct 2007
Location: PA
Posts: 358
Likes: 0
Received 0 Likes
on
0 Posts
. Besides that, Im done.....I think 
12-25-10, 07:17 PM
#64
Driver School Candidate
Join Date: Oct 2010
Location: Alberta
Posts: 30
Likes: 0
Received 0 Likes
on
0 Posts
Who did you send your harness to?
Thats the only thing thats scares me, doing my 1jz-r154 swap in my sc400.
I could probably attempt it myself, but I have a perfectly un-cut soarer wiring harness and dont feel like destroying anything lol.
How hard was putting it all back into the car(motor, trans, driveshaft, etc)
By the sounds of it, its not very hard. I guess I'm just nervous since I havent doen anything to this scale before lol
Thanks,
Aaron
Thats the only thing thats scares me, doing my 1jz-r154 swap in my sc400.
I could probably attempt it myself, but I have a perfectly un-cut soarer wiring harness and dont feel like destroying anything lol.
How hard was putting it all back into the car(motor, trans, driveshaft, etc)
By the sounds of it, its not very hard. I guess I'm just nervous since I havent doen anything to this scale before lol
Thanks,
Aaron
12-25-10, 07:25 PM
#65
Pole Position
Thread Starter
Join Date: Oct 2007
Location: PA
Posts: 358
Likes: 0
Received 0 Likes
on
0 Posts
Who did you send your harness to?
Thats the only thing thats scares me, doing my 1jz-r154 swap in my sc400.
I could probably attempt it myself, but I have a perfectly un-cut soarer wiring harness and dont feel like destroying anything lol.
How hard was putting it all back into the car(motor, trans, driveshaft, etc)
By the sounds of it, its not very hard. I guess I'm just nervous since I havent doen anything to this scale before lol
Thanks,
Aaron
Thats the only thing thats scares me, doing my 1jz-r154 swap in my sc400.
I could probably attempt it myself, but I have a perfectly un-cut soarer wiring harness and dont feel like destroying anything lol.
How hard was putting it all back into the car(motor, trans, driveshaft, etc)
By the sounds of it, its not very hard. I guess I'm just nervous since I havent doen anything to this scale before lol
Thanks,
Aaron
As for the harness, I sent it too Dr. Tweak....he did a really good job.
Thread
Thread Starter
Forum
Replies
Last Post
