SC400TT Project Car Stage II
03-16-08, 11:54 AM
#409
Congrats on getting the motor in. Trans in too?
Whats with the Torque converter? Is that a 6Cyl TQ? Chris and I were thinking about going with the smaller 6cyl TQ as you can get a higher stall then the larger 8cyl TQ.Good luck
Whats with the Torque converter? Is that a 6Cyl TQ? Chris and I were thinking about going with the smaller 6cyl TQ as you can get a higher stall then the larger 8cyl TQ.Good luck
03-16-08, 03:56 PM
#410
Ryan
Last edited by SC400TT; 03-18-08 at 08:26 PM.
03-17-08, 11:00 AM
#415
Pole Position
Haha don't sweat it, dude... At 74 pages long, no one is really expected to read the entire thread and know every step Ryan has taken. I don't think even Ryan remembers them all at this point. 
But for the record, the emblems are on page 44 of this thread.
Saying he's a stickler for the details is a gross understatement.
But for the record, the emblems are on page 44 of this thread.
Saying he's a stickler for the details is a gross understatement.
03-18-08, 10:19 PM
#418
Haha don't sweat it, dude... At 74 pages long, no one is really expected to read the entire thread and know every step Ryan has taken. I don't think even Ryan remembers them all at this point.
But for the record, the emblems are on page 44 of this thread.
Saying he's a stickler for the details is a gross understatement.
But for the record, the emblems are on page 44 of this thread.
Saying he's a stickler for the details is a gross understatement.
Ryan
03-18-08, 10:26 PM
#419
Well, getting the final touches done over the next few days so that I can send my car to Driven Concepts in Tampa...
Found more issues with the previous work done by Xtremeboost...It never seems to stop. Now, I found that the AEM Widwband harness had apparently been jerked through the hole in the floor of the car, and stripped the insulation off every wire that connected to the plug. More bare wires...
I also took the exhaust apart, and something was clanging in the pipe, I turned it upside down, and a 14 mm wrench fell out...
More "stuff"
I am certainly glad we are checking everything that was done by them...
Ryan
Found more issues with the previous work done by Xtremeboost...It never seems to stop. Now, I found that the AEM Widwband harness had apparently been jerked through the hole in the floor of the car, and stripped the insulation off every wire that connected to the plug. More bare wires...
I also took the exhaust apart, and something was clanging in the pipe, I turned it upside down, and a 14 mm wrench fell out... More "stuff"I am certainly glad we are checking everything that was done by them...
Ryan
Last edited by SC400TT; 03-19-08 at 06:52 AM.
