1992 "Tired of all my dailys turning into project cars" SC300/1JZGTE
#65
I am using a -4 line with a 12x 1.50 into the Holset.
Then connected to a 12 x 1.25 into the 1jz block.
My line came with a restrictor, but they are only for ball-bearing GT CHRAs. I'm going to leave it out.
This is a diesel turbo, so they get like 85lbs of pressure at idle!
I also got the shifter assembly extended, and the clutch pedal is mocked in.
All I need now is a Clutch Master, a Clutch slave, a line, and some fittings for the oil line and I'm finally finished!
Then connected to a 12 x 1.25 into the 1jz block.
My line came with a restrictor, but they are only for ball-bearing GT CHRAs. I'm going to leave it out.
This is a diesel turbo, so they get like 85lbs of pressure at idle!
I also got the shifter assembly extended, and the clutch pedal is mocked in.
All I need now is a Clutch Master, a Clutch slave, a line, and some fittings for the oil line and I'm finally finished!
#67
I caved and ordered some Marlin stuff from Drift motion.
Except I think I confused myself, and Aaron about one thing. The HX35 oil feed size.
From what I can find on Google, the oil inlet is 12 x 1.50 for the HX35. I think I got a SAE fitting, bummer.
We'll see.
Clutch pedal is installed.
Only thing left is tires for winter, and turbo fittings/couplers.
Except I think I confused myself, and Aaron about one thing. The HX35 oil feed size.
From what I can find on Google, the oil inlet is 12 x 1.50 for the HX35. I think I got a SAE fitting, bummer.
We'll see.
Clutch pedal is installed.
Only thing left is tires for winter, and turbo fittings/couplers.
#71
1JZ Single SC400
iTrader: (59)
Join Date: Jan 2009
Location: Alabama, Roll Tide!
Posts: 8,518
Likes: 0
Received 15 Likes
on
12 Posts
My thoughts exactly, when I installed mine, they seemed a little off. I also bought OEM SC300 pedals as well, and the bolts lined up perfect. Anyway, I had to remove the foot rest under the carpet and lay it back down. Mission accomplished. My foot keep hitting the rest no matter if I was bare foot or tennis shoes on.
#73
Lead Lap
iTrader: (3)
Join Date: May 2008
Location: Misawa,Japan or Deployed
Posts: 455
Likes: 0
Received 0 Likes
on
0 Posts
Can't wait to see this get running again. I have an HX35w on the way and swapping the turbine housing for the Bullseye Performane one. But if yours turns out good I might not need to do that. Hopefully by April I'll be out of this hole and back in the states to play catchup.