My 2jzgte swap
#227
breed: I think there were 2 inch vibrant couplers. They were a little big for the pipes and a little short on the length, maybe a quarter inch. I bought them individually and not in a three foot section like I did for my intercooler plumbing so I couldn't cut them to fit. But I have not had any issues with them.
#228
Thanks for the info man. Sadly, I looked, and I must have tossed my actuators for the IACV and EGCV. I guess it's a no go for me Oh well. One day I will be single and it won't matter
#229
#230
They are stock twins modified with inconel exhaust wheels and GT28 compressor wheels. Supposedly good for up to ~24psi reliably. I'm not really stretching the turbos at this point. I would love to one day put some cams in the car and see just what these turbos can do.
#236
Vwpride12: Thanks for the info man, what's next on your list?
Stockhatch: I myself just put in some GSC S1 Cams and man are they a Lumpy. I'm still on JDM twins but Stu's GT28 hybrid Twin upgrade does look pretty nice.
Stockhatch: I myself just put in some GSC S1 Cams and man are they a Lumpy. I'm still on JDM twins but Stu's GT28 hybrid Twin upgrade does look pretty nice.
#237
Next on the list will probably purchasing my waste gate. I guessing a tial 44. Trying to slowly acquire the parts so I'm not dropping a ton of cash at once. It sucks but it is a project. I broke my finger last night at the shop so that is going to be a speed bump for me. Did you have to do any valve adjustments after installing those cams?
#239
Ouch! Dang that's gotta Hurt. Take care of that bro. It's not like u can buy a new upgraded finger from Titan Motorsports.
I had to take measurements after installing the new GSC's then buy new Toyota shims. After that I had to take new measurments to make sure everything was in spec. I has to buy 11 shims, the rest were all in spec.
I sure hope I can get some good power out of these cams. Im still on JDM twins though. I also used Daddy Crower Titanium springs and retainers. Not to be confused with his son Brian Crowers cheaper stuff. The cams are
In.269/Ex.269
I had to take measurements after installing the new GSC's then buy new Toyota shims. After that I had to take new measurments to make sure everything was in spec. I has to buy 11 shims, the rest were all in spec.
I sure hope I can get some good power out of these cams. Im still on JDM twins though. I also used Daddy Crower Titanium springs and retainers. Not to be confused with his son Brian Crowers cheaper stuff. The cams are
In.269/Ex.269
Last edited by breed; 06-11-12 at 07:48 AM. Reason: BrainFart!!