CCJ22

iTrader: (26)

Modified and painted my gauge cluster.

c-low

iTrader: (1)

one brave **** lol lookin good

CCJ22

iTrader: (26)

Out with the megan EZ coilovers and in with the 12k 10k BCR's for slightly more low

Also had a custom built alternator that produces 300A for the new 7000watt amp/sub. (Coming soon)
Lastly, got my slightly extended studs and H&R 15mm spacers for the new BBK that will be here on the 12 of Feb.

CCJ22

iTrader: (26)

Lastly, we did a 1/3 widebody conversion on the rear fenders & a little front bumper modifying

CCJ22

iTrader: (26)

And the videos below can be seen in 1080p HD. The first is the alternator. Shows the massive coils in the last couple of seconds of the video. The second video is my unboxing of my new DR500G Blackvue in car cam. And the last video (not shot in HD) was us having fun in the body shop showing how much air the OLD sound system was pushing. If you look on my hood by the sunroof, you will see my cell phone dancing around from the ceiling shaking. NOTE THE LAST VIDEO HAS A CUSS WORD IN IT. BE CAREFUL PLAYING IT AT WORK. MODS, please advise if this violates forum rules, I will take down before getting an infraction. Thanks in advance.

RVCAis250

Ohmygod. There is so much tease on this page lol. I can't wait. I've been waiting too long haha

dorkacho

iTrader: (5)

wow i love this build ..

carlos

iTrader: (1)

"What the hell is this?"

lol - Loving all the work. Where did you get the alternator? How much was it if you don't mind me asking?

B16da9

iTrader: (7)

Good luck with the studs you need to pull the hubs off the spindle to do it properly.

carlos

iTrader: (1)

Yea, I replaced my studs when I had my Ichiba V1 spacers. It was a pain in the *** getting them to go all the way in. I checked my lugs 1 a day for a month to make sure they were still tight. I was always scared I would over torque them and break the stud, which I did once. There has to be a way to pull it and seat it all the way without taking off the hub.

brociouz

iTrader: (65)

So sick! Can't wait to see the final product.

CCJ22

iTrader: (26)

stud puller won't work? Great.
It's bad enough I'm removing the rotors for the new bbk.... Pay to play I suppose.

Thanks all for the kind words

CCJ22

iTrader: (26)

Had it made by company called Tenney alternators. $369
he's on Facebook too tell him Jay sent ya.

carlos

iTrader: (1)

I think you'll be ok with a stud puller. I had already started before I realized how hard it would be to get them seated but I got it done eventually.

CCJ22

iTrader: (26)

Yea, everyone I've spoken with has not removed the hub from the spline but I think it will make it easier.
I'll research more before the BBK gets in.