When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
My new cup holder came in, as well as some other parts. going to be posting some more pictures when I get a chance. I'm still unpacking from my flight home from D.C.
Since you have to weld the greddy intake to the lower runners could i use my 2jzge lower runner and weld it to the greddy intake? Or do the ports don't line up that way?
I'm not sure on that one. The intake plenum I had came with an adapter for the lower runners. You don't "have" to weld it, but I've been told you should in order to have a proper seal. I don't know if the lower GE runners are the same. Sorry.
Originally Posted by jwin
Since you have to weld the greddy intake to the lower runners could i use my 2jzge lower runner and weld it to the greddy intake? Or do the ports don't line up that way?
Man just looking at the pics I could tell that was a pita smh more power to you cause I don't think my small case of ADD would allow me to be patient enough to put all that back together
Clutch and Flywheel installed. Engine in the engine bay for a test fit. Have to measure and run all the lines and wires. This includes building a wiring harness. I have to route all the sensors and re-run the engine bay wires including lighting. Then I have to turn the turbo and route the charge piping. Figure out throttle cable, coolant and vacuum lines... ETC....