CatManD3W SC300 Ongoing Build...
#907
Thread Starter
Pole Position
iTrader: (18)
Joined: May 2013
Posts: 2,207
Likes: 25
From: Pittsburgh, PA
Officially placed order today for Tremec t56 Magnum and shifter relocation. I opted to go with American Powertrain for the order.
Only part is the transmission is on backorder....and they will not be arriving for shipment until end of February or Early March.....
Only part is the transmission is on backorder....and they will not be arriving for shipment until end of February or Early March.....
#914
Thread Starter
Pole Position
iTrader: (18)
Joined: May 2013
Posts: 2,207
Likes: 25
From: Pittsburgh, PA
Finished off a few items from the "to do" list over this past week.
Since removal of the heater core it left the exposed holes in the firewall that needed to be covered. I ended up using the original pieces as a template and fabricated some new pieces out of aluminum and attached them using seam sealer.
I wanted to re-purpose the center vent trim to fit my gauges in and here is the design I came up with. Also shaved the passenger side vent as well. I reused my existing innovate air/fuel and boost gauges and added water temp/voltage and oil press gauge. All gauges are innovate motorsports.
Since removal of the heater core it left the exposed holes in the firewall that needed to be covered. I ended up using the original pieces as a template and fabricated some new pieces out of aluminum and attached them using seam sealer.
I wanted to re-purpose the center vent trim to fit my gauges in and here is the design I came up with. Also shaved the passenger side vent as well. I reused my existing innovate air/fuel and boost gauges and added water temp/voltage and oil press gauge. All gauges are innovate motorsports.