MN 2JZ-GTE/R154 Swap
The following users liked this post:
joeisahoe (01-20-21)
#287
Pole Position
Thread Starter
I am pretty bad at updating the forum just because it takes longer to post. Sorry for the delay guys. I finally received my engine parts from Hypertune and the car goes to its final fabrication shop visit May 1st. So I cant wait to get it back. Once the car returns from the fab shop it will be going straight to the body shop for work and paint. Here are some of the pictures of the Hypertune parts.
Last edited by ELLeon; 04-29-21 at 06:10 AM.
The following users liked this post:
Answer300 (04-29-21)
#289
Pole Position
Thread Starter
After a long time trying to find a shop that could help me finish the GS300, I had to take the car down to Orlando Florida to get finished and ready for our SEMA debut.
This was back in July 2021, we made it down to Florida and dropped it of at Attacking The Clock Racing. We had a tight deadline of making it to the ToyoTires Treadpass booth. So it was alot of running around. Last minute overnighting of parts and alot of stress.
This was back in July 2021, we made it down to Florida and dropped it of at Attacking The Clock Racing. We had a tight deadline of making it to the ToyoTires Treadpass booth. So it was alot of running around. Last minute overnighting of parts and alot of stress.
The following users liked this post:
firelizard (11-13-21)
#291
Pole Position
Thread Starter
All of our initials plans changed, from having air suspension, a R154 or V160, or a BMW 335i transmission. We ended up going with a BC Racing ER coilovers, DCT transmission out of a E92 M3, Ross Performance Dry Sump, Nuke Performance AirJacks, Fuel Safe fuel cell and dry break. Thats just some of the changes we made to the car. Next steps is getting her on the dyno, so I can finally drive her around the track.
Thread
Thread Starter
Forum
Replies
Last Post