When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
This update doesn't look much different considering it's just the otherside. Except for dealing with the fuel door. I'm not sure what I'm going to do with it yet I haven't decided. I might relocate it on the sail panel like a Maserati or just put a small round flush pop out on the top of the quarter or I might just leave it where it is and change it to the new angle.
coming along nicely. did you say your doing a 3is front
There's a good chance I'm going to put the new 2016 RX headlights and front end on here. The way I'm going to stretch the fenders I can make it work and flow into my mods nicely. Because of the height it won't need a lip kit.
If the cost is more than I want to spend then I'm going to do the 3gen with the 3gen is350 headlights.
There's a good chance I'm going to put the new 2016 RX headlights and front end on here. The way I'm going to stretch the fenders I can make it work and flow into my mods nicely. Because of the height it won't need a lip kit.
sounds good. deffo want to see this once its finished.
If the cost is more than I want to spend then I'm going to do the 3gen with the 3gen is350 headlights.
will be interesting to see how you fabricate that.
Your swap looks nice by the way I like the color.
thanks, the colour is very unusual but it works. just deciding on a set of wheels now. can't believe the price yo go on your set.
Very clean my friend.Bravo to you.I can't wait to see the front.I want to ask you how difficult is to make the wald rear wing out of metal so that you won't need fiberglass or anything and without raising the quarters?How much would someone charge to make it look perfect as (in my opinion)Sebastian's was?
Very clean my friend.Bravo to you.I can't wait to see the front.I want to ask you how difficult is to make the wald rear wing out of metal so that you won't need fiberglass or anything and without raising the quarters?How much would someone charge to make it look perfect as (in my opinion)Sebastian's was?
I really like that *** for my beauty
This would be time consuming and expensive to do. The back of that spoiler has a compound curve with a negative arch. Not easy to duplicate in metal but can be done.
05-09-16, 05:11 PM
