EXACT Motorsports: Exclusive IS-F Custom Finned Diffuser
#106
New shipment has arrived with a new and improved fitment!
Installation for locals is available, just ask!
Just dropped off a shipment of 10 pieces going to mostly east coast - what's up with Florida and Lexus owners!
thanks Clublexus!
Installation for locals is available, just ask!
Just dropped off a shipment of 10 pieces going to mostly east coast - what's up with Florida and Lexus owners!
thanks Clublexus!
#107
#108
#109
No pictures yet but will snap some next time. Most guys who get theirs installed is so happy they take off right away and we forget to take pics!
P.S We now offer Stainless screws as an option at no charge - just ask!
P.S We now offer Stainless screws as an option at no charge - just ask!
#112
#113
For those in Florida... I do recommend the stainless screws to avoid surface rust from s4plays original screws
#114
#119
PM's replied!
For installing the diffuser, the best process is to first center the diffuser (having a friend helps out and also if you have a lift it will make things easier)
Use a piece of small masking tape to mark the center since this it very important. The diffuser should line up with the outer edge of the bumper but NOT protrude past it if you are standing over the rear bumper. So in other words if you stand looking straight down, you should not see the end of the diffuser.
Once you are sure it's centered, only install the middle screw and slowly work your way out. By only attached the middle screw, it will give you a chance to pivot/swing the piece until it's even on both sides. Do NOT start with the outermost screws.
Hope this tidbit helps!
For installing the diffuser, the best process is to first center the diffuser (having a friend helps out and also if you have a lift it will make things easier)
Use a piece of small masking tape to mark the center since this it very important. The diffuser should line up with the outer edge of the bumper but NOT protrude past it if you are standing over the rear bumper. So in other words if you stand looking straight down, you should not see the end of the diffuser.
Once you are sure it's centered, only install the middle screw and slowly work your way out. By only attached the middle screw, it will give you a chance to pivot/swing the piece until it's even on both sides. Do NOT start with the outermost screws.
Hope this tidbit helps!