Change Passenger Side Low Beam Bulb
#1
Driver School Candidate
Thread Starter
Join Date: Oct 2017
Location: GA
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Change Passenger Side Low Beam Bulb
I'm sure there's a better way to do this, but I tried reaching into the cramped area on the passenger side to get to the low beam to replace a dead bulb. I can't get it out as I can only get 1 hand in there. What is the correct way to do it?
#4
Pole Position
It's just a little difficult if you have big hands.
I replaced with a FAN LESS HIGH POWERED LED bulb. All good.
I also replaced the fogs with the same type LED bulbs. The 2013 CT200h uses the same low beam and fog bulbs. It's more involved with fog light replacement bc you have to remove the wheel liners PARTIALLY. NO need to take the wheel off, just turn the steering wheel to the opposite side of you are working on.
Wear some gloves (nitrile).....so you don't get any skin oil on the new bulbs.
I replaced with a FAN LESS HIGH POWERED LED bulb. All good.
I also replaced the fogs with the same type LED bulbs. The 2013 CT200h uses the same low beam and fog bulbs. It's more involved with fog light replacement bc you have to remove the wheel liners PARTIALLY. NO need to take the wheel off, just turn the steering wheel to the opposite side of you are working on.
Wear some gloves (nitrile).....so you don't get any skin oil on the new bulbs.
Thread
Thread Starter
Forum
Replies
Last Post
boobobo
IS - 2nd Gen (2006-2013)
4
01-20-17 11:55 AM