CV boot replacement problem
11-02-08, 09:03 AM
#1
Driver School Candidate
Thread Starter
Join Date: Nov 2008
Location: canada
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
CV boot replacement problem
I have 1999 ES-300 and my mechanic could not replace the boot. He said he couldn't seperate the driveshaft from bearing nor remove the intermediate shaft from the transmission.
11-02-08, 12:00 PM
#2
which side. i think its youre referring to the passenger side. if so
on the driveshaft mount , there is a lock nut that must be loosened from the bottom, and a c-clip holding it in. once those are out, you should be able to yank on it and have it removed,
if its the drivers side, this one is a bit trickier, as there is a c-clip insidethe transmission, and you must yank on it so that it kind of pops out.
Charley
on the driveshaft mount , there is a lock nut that must be loosened from the bottom, and a c-clip holding it in. once those are out, you should be able to yank on it and have it removed,
if its the drivers side, this one is a bit trickier, as there is a c-clip insidethe transmission, and you must yank on it so that it kind of pops out.
Charley
11-02-08, 07:56 PM
#4
yeah, also, it rides on a center bearing/engine mount, that usually gets seized up, you may have to end up connnecting a slide hammer to your axle and pull it out, but yeah, that center bearing contains a lock screw on the bottom and a c-clip, other than that, nothing else to it
Charley
Charley
Thread
Thread Starter
Forum
Replies
Last Post
93sc3005sp
SC400 / 300 Classifieds
5
06-02-10 10:10 PM
