Diy LED Mirrow Turn Signals
#32
Pole Position
Thread Starter
Join Date: Mar 2010
Location: mn
Posts: 243
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://www.clublexus.com/forums/images/icons/icon1.gif)
its been a WHILE since i've been here on the thread... I was actually interested, in finding out where the turn signal wire is located... therefore i can connect my side led's and see if it works... so far i've got the left side (driver) installed but the passenger is ****ed due to when i got hit on the side, and they've glued the mirror to the frame, so i gotta pry that off w/o damaging... but one at a time... so if you can, can u tell me where the location of the turn signal circuit is, so that i can connect it
#33
![Default](https://www.clublexus.com/forums/images/icons/icon1.gif)
You want just enough to accent the car nicely, but not too much to throw the rest of the car off balance. . .it looks gorgeous by the way. . .a nice custom appearance too!!!
#34
Pole Position
Thread Starter
Join Date: Mar 2010
Location: mn
Posts: 243
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://www.clublexus.com/forums/images/icons/icon1.gif)
@xXTimmayXx thanks very much! It was well worth the few dollars I spent! But I just recently discovered the the last 2 LED's on the passenger side have burnt out so I will need to order a new strip for that side and replace it! But I recently cleaned up my wiring I did on the signals and I made a disconnect point right below the tweeter behind the door panel so if the mirror ever needs to be painted, or when I replace the LED strip I can simply disconnect right there, install the new LED, crimp on a male connector on the end of that wire and connect them! It made it so much easier, wish I would've thought of this right away!
Thread
Thread Starter
Forum
Replies
Last Post