1998 ES300 shimmy shake when turning to the right
#1
Driver School Candidate
Thread Starter
Join Date: May 2011
Location: wi
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
1998 ES300 shimmy shake when turning to the right
Hello,
I have a 1998 ES300 and after replacing the
Strut, Link arm, Lower ball joint, Outer tie rod, Inner tie rod, Rotor on both sides
I have a shimmy shake when turning to the right and when stopping, it is coming from the driver’s side. Just got new tiers as well. All items installed have been torque to spec.
The bushings look fine and when I have the car on jack stands I don’t have any play when pushing and pulling side to side and up and down. I could take it in to the dealer and pay $100 for them to tell me whats wrong but was hoping maybe someone out here could give me some ideas as this site has helped with postings in the past.
Thanks for any help
madpup
I have a 1998 ES300 and after replacing the
Strut, Link arm, Lower ball joint, Outer tie rod, Inner tie rod, Rotor on both sides
I have a shimmy shake when turning to the right and when stopping, it is coming from the driver’s side. Just got new tiers as well. All items installed have been torque to spec.
The bushings look fine and when I have the car on jack stands I don’t have any play when pushing and pulling side to side and up and down. I could take it in to the dealer and pay $100 for them to tell me whats wrong but was hoping maybe someone out here could give me some ideas as this site has helped with postings in the past.
Thanks for any help
madpup
Last edited by madpup; 05-25-11 at 10:28 AM.
Thread
Thread Starter
Forum
Replies
Last Post
velani
ES - 1st to 4th Gen (1990-2006)
5
01-16-17 07:33 PM
es300lexy
ES - 1st to 4th Gen (1990-2006)
5
07-01-15 09:12 AM
es300lexy
ES - 1st to 4th Gen (1990-2006)
0
06-24-15 10:54 PM
canucklehe
ES - 1st to 4th Gen (1990-2006)
4
01-27-13 10:08 PM
ebnub
ES - 1st to 4th Gen (1990-2006)
4
08-24-10 07:53 PM