92-96 Radio and Climate light bulbs - LCD backlight
#76
It is not very easy to do, but here is how.
Once you have the climate control apart, take all the screws out that you see (that hold the front cover to the board). Then I think there are three screws that hold the white lcd housing to the board.
CAREFULLY bend the entire lcd back, using the white housing to hold on to. You will see the place where the three bulbs are attached to the board.
Bend the lcd back enough to remove the white housing completely. It will make it much easier to solder the new bulbs in place with the housing out of the way.
Order the new bulbs from:
Pioneer Parts 1-800-457-2881
Part # CEL1247
I did this several times and the lcd didn't break, so just be careful and you should be fine.
Once you have the climate control apart, take all the screws out that you see (that hold the front cover to the board). Then I think there are three screws that hold the white lcd housing to the board.
CAREFULLY bend the entire lcd back, using the white housing to hold on to. You will see the place where the three bulbs are attached to the board.
Bend the lcd back enough to remove the white housing completely. It will make it much easier to solder the new bulbs in place with the housing out of the way.
Order the new bulbs from:
Pioneer Parts 1-800-457-2881
Part # CEL1247
I did this several times and the lcd didn't break, so just be careful and you should be fine.
Last edited by jerlands; 12-04-20 at 07:58 PM.
Thread
Thread Starter
Forum
Replies
Last Post
FRQ
LS - 1st and 2nd Gen (1990-2000)
6
10-30-18 08:23 AM
nclark
ES - 1st to 4th Gen (1990-2006)
1
08-13-12 09:13 PM