2000 es300 torque specs
#1
Driver School Candidate
Thread Starter
Join Date: Sep 2012
Location: MN
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
2000 es300 torque specs
Hello does anyone have the torque specs for the intake manifold & plenum bolts for a 2000 es 300 handy? Let me know I appreciate it
#2
I think this is what you want, from a 97 manual: Probably the same.
INSTALL INTAKE MANIFOLD ASSEMBLY
(a) Install the intake manifold, delivery pipe and injectors assembly
with the 9 bolts, 2 plate washers and 2 nuts. Uniformly
tighten the bolts and nuts, in several passes, in the
sequence shown.
Torque: 15 N·m (150 kgf·cm, 11 ft·lbf)
INSTALL AIR INTAKE CHAMBER ASSEMBLY
(a) Using an 8 mm hexagon wrench, install a new gasket and
the air intake chamber assembly with the 2 bolts and 2
nuts. Uniformly tighten the bolts and nuts in several
passes.
Torque: 43 N·m (440 kgf·cm, 32 ft·lbf)
INSTALL INTAKE MANIFOLD ASSEMBLY
(a) Install the intake manifold, delivery pipe and injectors assembly
with the 9 bolts, 2 plate washers and 2 nuts. Uniformly
tighten the bolts and nuts, in several passes, in the
sequence shown.
Torque: 15 N·m (150 kgf·cm, 11 ft·lbf)
INSTALL AIR INTAKE CHAMBER ASSEMBLY
(a) Using an 8 mm hexagon wrench, install a new gasket and
the air intake chamber assembly with the 2 bolts and 2
nuts. Uniformly tighten the bolts and nuts in several
passes.
Torque: 43 N·m (440 kgf·cm, 32 ft·lbf)
Last edited by tomf; 02-11-15 at 03:39 PM. Reason: correct spelling
Thread
Thread Starter
Forum
Replies
Last Post
c50sooner
LS - 1st and 2nd Gen (1990-2000)
10
10-01-13 03:31 PM