Check engine light came on today
#16
Pole Position
Thread Starter
Thank you, sir.
It still hasn't come back on. I'm sure it will but who knows when.
#17
Pole Position
Thread Starter
It's back on to stay so time to replace it. I've search but can't find a part #.
I think it's 89465-33370 but I can't find any reference that unambiguously says it is.
Thanks
I think it's 89465-33370 but I can't find any reference that unambiguously says it is.
Thanks
#18
Pole Position
Thread Starter
Every freaking site that shows this sensor tell me it fits my vehicle but not the first one tells me which O2 sensor it is. What I need is Bank 1 Sensor 2. Whether it fits my car or not is irrelevant if it's the wrong sensor.
#19
Pole Position
Thread Starter
I asked a seller on amazon and they verified that it was Bank 1 Sensor 2. I have no clue why this info isn't readily available but won't order unless I know the heck it is.
#20
Just buy the Denso part. Denso makes the Lexus parts. The Denso part is a 1/3 the price of the Lexus part. If you insist on the Lexus part do this to verify it's the same part.
Go here. http://densoautoparts.com/find-my-pa...icle-selection You get part number 234-4064.
Cross reference your part number 89465-33370 with Denso. Go here. http://www.oxygensensor-crossreferen...ta/89465-33370
You want Bank one, Sensor two or as Denso describes it downstream rear. That is part number 234-4064.
or
Go here. http://densoautoparts.com/find-my-pa...icle-selection You get part number 234-4064.
Cross reference your part number 89465-33370 with Denso. Go here. http://www.oxygensensor-crossreferen...ta/89465-33370
You want Bank one, Sensor two or as Denso describes it downstream rear. That is part number 234-4064.
http://www.amazon.com/Denso-234-4064-Oxygen-Sensor/dp/B000IYBFE8/ref=sr_1_1?ie=UTF8&qid=1434745881&sr=8-1&keywords=234-4064&pebp=1434745890403&perid=04E4H1RFBXGZRDJ3FGBY
or
#22
Pole Position
Thread Starter
Just replaced the sensor. It was stupid easy to gedt to and at just the right angle to get a wrench on it.
but.....
The stupid made me cry and cuss. It was not easy to get to and I had a helluva time getting it to separate. I literally fought with it a good hour and finally got it to release. At that poiunt I was home free. Job done.
But while under there I noticed an oil leak. It's been over 5k since I changed the oil and it was only a half a quart low so it isn't much of a leak. Hard to tell where it's coming from but both sensor plugs were covered in it and you could tell where the wind spread it down the oil pan. This will have to wait for another day.
but.....
The stupid made me cry and cuss. It was not easy to get to and I had a helluva time getting it to separate. I literally fought with it a good hour and finally got it to release. At that poiunt I was home free. Job done.
But while under there I noticed an oil leak. It's been over 5k since I changed the oil and it was only a half a quart low so it isn't much of a leak. Hard to tell where it's coming from but both sensor plugs were covered in it and you could tell where the wind spread it down the oil pan. This will have to wait for another day.
Thread
Thread Starter
Forum
Replies
Last Post
McMuffin
ES - 1st to 4th Gen (1990-2006)
4
11-02-08 05:20 PM