Front , rear and side kit..... give me some times so I can get a better view of the car... update it later...
enjoy...

 

Front

 

rear... the ball is just to show how low it is....

 

rear.... the ball is just to show you how low it is.....

 

oh.. btw I also put in new rotors,,, Brambo rotors

 

that was nice...eheh.....
finally our car get some kit....

 

rims bent...kit looks nice

 

what is your ground clearance..??
here is mine..

 

here is mine

 

how about this

 

and this

 

that car looks HOT,minus the exhaust. The exhaust throws it off, looks to cheesey . How much did it cost you ?

 

Looks good. You need to find a rear valance piece for your rear bumper. The dual exhausts make it look unbalanced.

 

just one question what is rear valance piece and where can I get one...
and why is my dual exhausts make it look unbalanced???
I think it's because of the rear piece of the camry is little square and it had little little problem installing it.. so it make it look unbalanced..... if you guys have any idea to solve it please let me know... thankz

 

Hello guys. MCV20 your kit looks good from the only picture i saw. On the other hand, George, you didn't sand down the front parts? because i can see that the parts are sticking out outwards. i think it would be better if you take the front, and rear parts to body shop, and request them to sand down the inside of the parts to make them fir perfectly. That's what i did. Also for both of you watch out while you drive with the kit on, it's lower than you think, and when i had mine i scratched it a lot.

p.s. how the kits looked like when they were on my car