Singlesville
#91
Lexus Fanatic
iTrader: (7)
remember the other day when i was by you house and car sat idling while we talked where was i idling at , in the high 14's to low 15's , no o2 fb enabled
#92
Lexus Test Driver
Thread Starter
iTrader: (3)
Join Date: Jan 2009
Location: fl
Posts: 1,163
Likes: 0
Received 0 Likes
on
0 Posts
I've gotten quite a few phone calls from this thread today LOL! The end result of this is maximizing the most safe power for all of us. Ed, if your coolant decides to stay put, any idea when your hitting the rollers?
#94
Lexus Test Driver
Thread Starter
iTrader: (3)
Join Date: Jan 2009
Location: fl
Posts: 1,163
Likes: 0
Received 0 Likes
on
0 Posts
Injectors to be cleaned? Excuses excuses...lol... witchhunter is awesome for that btw..and CHEAP. Used to send all my shaved nissan injectors to them. Why are you cleaning them since you run on the rich side a bit?
#95
Lexus Fanatic
iTrader: (7)
my a/f at 21psi is rock steady 11.5 when i goto 23.5 11.9-12.1 thats why i need to retune since all boostleaks have been cleared and have new turbo on
alpha wants to make sure injectors are spraying cleanly and evenly prior to retune
darin at titan the other day emailed me as well and highly recc once a year to have performance injectors cleaned
so you have used witchunter , i have read about them but i was going to send them to rc eng directly
#96
Lexus Test Driver
Thread Starter
iTrader: (3)
Join Date: Jan 2009
Location: fl
Posts: 1,163
Likes: 0
Received 0 Likes
on
0 Posts
11.5 is the rich side....I thought I recall you saying 11.0-11.5. Its going to take a LOT more than 11.0 to wash down a cylinder wall. Look at how insanely rich the GTE runs stock....9.Xs My point was, if you had an injector flowing a touch under than what it is rated, the margin built into your tune would accommodate for it. Did you buy the injectors new?
RC seems to be the common name...just had a friend send them to RC and one week after back in the car it seized up...could very much be isolated experience. Have you checked with Fuel Injector Clinic in Palm Beach? My 750s came from him with and all where flow matched to 751cc except one that was 750cc.
RC seems to be the common name...just had a friend send them to RC and one week after back in the car it seized up...could very much be isolated experience. Have you checked with Fuel Injector Clinic in Palm Beach? My 750s came from him with and all where flow matched to 751cc except one that was 750cc.
#97
Pole Position
iTrader: (3)
If you have RC Injectors I suggest sending them out to them for cleaning/caliberation. I had mine done back in March when I had the stuck injector issue. If my memory is correct it was $12.00 per injector and the turn around was quick. They were overnighted Monday and were back on Wednesday...
#98
Lexus Fanatic
iTrader: (7)
it will and has washed down cylinder walls diluting the oil thining it to the point of little to no viscosity and bam bearings fail.. it happens often with running to rich in high boost
i have personally seen this occur
stock tt mode and i do mean stock you can get away with it but not under higher boost applications
running mid 11'a a/f gives a safety margin for rem wb takes a overall avg of cyls how do you know cyl 6 is not running at 12.5 while wb shows avg of 11.8 not a good mix imo running 23psi on pump you feel me (alpha taught me this concept which i confirmed with darin,and john reed)
my point is 11.3 to 11.6 at max boost to me is safe .. no need to run 10.9 etc for at that point you are just flooding cyl with more fuel making it harder to ignite..some like to run around 12 but there i see egt climb to fast when mid 11's egt stay nice and power delivery is smooth across full rpm band
Last edited by lexforlife; 09-15-09 at 02:33 PM.
#100
Lexus Test Driver
Thread Starter
iTrader: (3)
Join Date: Jan 2009
Location: fl
Posts: 1,163
Likes: 0
Received 0 Likes
on
0 Posts
High 10s is STILL not washing down your cylinder walls with fuel, sorry to say...regardless of whether its a JZ or not. I know too much fueling goes past the the rings, thins the oil etc etc, but running in the 10.X will NOT cause that unless you have already a shoddy ring seal or some serious blow bye to start. In your situation where you saw this occur there could be several things causing the thinning oil including crank case ventilation at higher boost. Matt Faul and DaveH where reportedly pushing out nearly a quart of oil each pass at 30+psi due to ventilation issues (and possibly a loose ring gap to account for thermal expansion). Speaking of washing walls...ask Stephan @ STP...his AEM EMS FAILED and locked the injectors open flooding the engine with fuel thinning the oil and shortly after spun a bearing. Sorry had too There is a story like this out there for every tuning solution from SAFC to MoTeC
Of course the wideband takes into an account of all the cylinders...as nice and ballerific as some of these cars are we are not running individual EGT or Widebands for individual cylinder trim. The best alternative to that is to read each plug after a hard pull.
The only thing I see about running say 10.8AFR vs 11.5AFR at 20psi vs 10psi would be on the basis of cylinder leakage...meaning you are going to get a certain amount of blowbye regardless...more boost = more blowbye, which means more into the oil. Frankly we are talking about a smaller difference here in overall amount of fuel and really just giving up power to run that rich. I really wish I sent in the oil sample for evaluation before going single (forgot as rushing to prepare for last friday) because the car was running in the 10s for the last 2 years at 19psi on the JDM twins making ~ 400whp. That is still a lot of boost and dead rich. I can tell you this, at my first oil change, it didn't smell flooded with fuel
Lets face it...none of us run that rich on a proper setup anyways, so why debate it?
I have not used FIC for there cleaning abilities, so I can't vouch for them, they are just semi-local as a matter of convenience though...
Of course the wideband takes into an account of all the cylinders...as nice and ballerific as some of these cars are we are not running individual EGT or Widebands for individual cylinder trim. The best alternative to that is to read each plug after a hard pull.
The only thing I see about running say 10.8AFR vs 11.5AFR at 20psi vs 10psi would be on the basis of cylinder leakage...meaning you are going to get a certain amount of blowbye regardless...more boost = more blowbye, which means more into the oil. Frankly we are talking about a smaller difference here in overall amount of fuel and really just giving up power to run that rich. I really wish I sent in the oil sample for evaluation before going single (forgot as rushing to prepare for last friday) because the car was running in the 10s for the last 2 years at 19psi on the JDM twins making ~ 400whp. That is still a lot of boost and dead rich. I can tell you this, at my first oil change, it didn't smell flooded with fuel
Lets face it...none of us run that rich on a proper setup anyways, so why debate it?
I have not used FIC for there cleaning abilities, so I can't vouch for them, they are just semi-local as a matter of convenience though...
#101
Lexus Fanatic
iTrader: (7)
i didnt say high 10's i said running 10 to mid 10's = not good
running 10 to mid 10 consistently will dilute your oil , nuff said running mid to high 10's is actually killing power for you are now making spark more diff to ignite
why add that into the equation.. all tuners will agree running closer to high 11's to 12 is ideal but no recc on pump gas as opposed to 110 or c16 given its forgiving higher octane nature
so hence why alpha on pump will stay on the crest of being safe , not to rich not to lean for the sake of bad gas
running 10 to mid 10 consistently will dilute your oil , nuff said running mid to high 10's is actually killing power for you are now making spark more diff to ignite
why add that into the equation.. all tuners will agree running closer to high 11's to 12 is ideal but no recc on pump gas as opposed to 110 or c16 given its forgiving higher octane nature
so hence why alpha on pump will stay on the crest of being safe , not to rich not to lean for the sake of bad gas
#102
Lexus Fanatic
Boy at this rate I'd hate to see what a pissing contest would look like..LOL
But I have to admit all this reading is very edjamacational ..
E manage running 24 psi on pump gas running in the low 11's to mid 11's . To each his own can !!! Can't we all just boost along..
But I have to admit all this reading is very edjamacational ..
E manage running 24 psi on pump gas running in the low 11's to mid 11's . To each his own can !!! Can't we all just boost along..
#103
Lexus Fanatic
iTrader: (7)
you guys on piggybacks need to LEARN a/f are just a part although critical part , but just part of the equation when starting to creep up in boost
just because a/f are in the 11's does not mean timing is where it needs to be and the higher on pump gas you go the more critical timing settings become ..
#104
Lexus Fanatic
iTrader: (7)
heres a video of a supra racing a bike
esp for john , take note of his wideband and his egt gauge in the middle pillar pod
he was running on stock ecu with twin pumps so fuel was there but timing was off
although a/f remained stable egts went thru the roof and bam
http://www.youtube.com/watch?v=w2sQ9...om=PL&index=25
esp for john , take note of his wideband and his egt gauge in the middle pillar pod
he was running on stock ecu with twin pumps so fuel was there but timing was off
although a/f remained stable egts went thru the roof and bam
http://www.youtube.com/watch?v=w2sQ9...om=PL&index=25
#105
Lexus Test Driver
Thread Starter
iTrader: (3)
Join Date: Jan 2009
Location: fl
Posts: 1,163
Likes: 0
Received 0 Likes
on
0 Posts
We've all seen that video of epic fail....I have not recommended staying at stock timing, hence the reason this debate started. Its not just "guys with piggy backs" its any buddy running into the 500whp+ range where timing of the factory ECU becomes a problem...remember, there are tons of 2JZGTE engines running around near the 500hp mark on the stock ECU, stock fuel and stock timing. Many of those engines are running just fine and have for a while.
You are NA-T which is a whole different planet, and frankly much more what I am used to dealing with...than factory turbo setups.
You are NA-T which is a whole different planet, and frankly much more what I am used to dealing with...than factory turbo setups.