56K beware...pics of JDM lights(finally after all the waiting)
10-27-05, 03:55 PM
#1
Lead Lap
Thread Starter
Join Date: Sep 2005
Location: NJ
Posts: 438
Likes: 0
Received 0 Likes
on
0 Posts
56K beware...pics of JDM lights(finally after all the waiting)
They all came in 3 seperate days. 
JDM FOGS(EMS from Japan)
JDM Front Housings
Driver Side
Passenger Side
JDM Tails with Aristo Center piece
Well that's the whole lot of it. Now I can either wait till I get my kit put on and then put the lights on or just put it on now anyway. Boxes are really piling up in my garage. Pretty soon the mods will just pile up and i wont be able to park my car anymore...lol
Damn NJ and the crazy snow...good thing I like snowboarding
JDM FOGS(EMS from Japan)
JDM Front Housings
Driver Side
Passenger Side
JDM Tails with Aristo Center piece
Well that's the whole lot of it. Now I can either wait till I get my kit put on and then put the lights on or just put it on now anyway. Boxes are really piling up in my garage. Pretty soon the mods will just pile up and i wont be able to park my car anymore...lol
Damn NJ and the crazy snow...good thing I like snowboarding
10-27-05, 04:38 PM
#3
O.C. Lucky Strike Fanatic
iTrader: (1)
Join Date: Dec 2002
Location: So.Cal.
Posts: 8,675
Likes: 0
Received 0 Likes
on
0 Posts
When I ordered my JDM fogs, they came with clips on the end to cover the screws. They are different than the USDM ones. Did yours come with them?
THe headlights look nice, but the bad thing about them is that they aim at opposing traffic so becareful. Everything is looking great!
THe headlights look nice, but the bad thing about them is that they aim at opposing traffic so becareful. Everything is looking great!
10-27-05, 05:30 PM
#5
Lexus Fanatic
Join Date: Nov 2001
Location: California
Posts: 5,203
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by LEXISM
what the difference? jdm...usdm
there is an extra bulb in the headlight, basically its like a DRL.
the orange amber piece is on the inside,
there's a small bump on the corner part of the headlight.
its rare.
foglights
they are yellow and the yellow film is on the inside. kinda like the 2nd gen gs yellow fogs
rear tail lights
it says Aristo instead of gs300
the white part is a little darker. closer to a shade of grey.
10-27-05, 05:35 PM
#6
Lead Lap
Thread Starter
Join Date: Sep 2005
Location: NJ
Posts: 438
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by LexAristo
When I ordered my JDM fogs, they came with clips on the end to cover the screws. They are different than the USDM ones. Did yours come with them?
THe headlights look nice, but the bad thing about them is that they aim at opposing traffic so becareful. Everything is looking great!
THe headlights look nice, but the bad thing about them is that they aim at opposing traffic so becareful. Everything is looking great!
What clips are you talking about? I opened up the boxes again, but nothing else is inside. This will suck...do I need the clips? you have any pics
Trending Topics
10-27-05, 08:36 PM
#8
O.C. Lucky Strike Fanatic
iTrader: (1)
Join Date: Dec 2002
Location: So.Cal.
Posts: 8,675
Likes: 0
Received 0 Likes
on
0 Posts
Here's a pic of the clip I am refering to. However it may be hard to see because I have yellow clear bra film over it. Did you try to test fit it? I have the jdm bumper so it fits flush, but when I tried putting my old is300 fog light in the jdm bumper, it was too big.
10-28-05, 08:32 AM
#10
Lead Lap
Thread Starter
Join Date: Sep 2005
Location: NJ
Posts: 438
Likes: 0
Received 0 Likes
on
0 Posts
Is it that piece I put an arrow to?
IF it is than well crap...I don't have it...I did a test fit and it seems to fit just fine, though I'm not quite sure where exactly to screw it in. I need to get out and take pics of my front bumper. It's the veilside so I don't there should be much of a problem. Where can I get the clips if I need them?
10-28-05, 05:24 PM
#13
O.C. Lucky Strike Fanatic
iTrader: (1)
Join Date: Dec 2002
Location: So.Cal.
Posts: 8,675
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Tramix
Is it that piece I put an arrow to?
IF it is than well crap...I don't have it...I did a test fit and it seems to fit just fine, though I'm not quite sure where exactly to screw it in. I need to get out and take pics of my front bumper. It's the veilside so I don't there should be much of a problem. Where can I get the clips if I need them?
I don't think you can purchase the clips, but I would use the stock clips from the usdm fogs to cover that exposed area.
10-29-05, 06:13 AM
#14
Driver School Candidate
Join Date: Jul 2005
Location: CALIFORNIA
Posts: 46
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by LexAristo
I don't think you can purchase the clips, but I would use the stock clips from the usdm fogs to cover that exposed area.
