i need help please
10-01-07, 09:05 AM
#1
Driver School Candidate
Thread Starter
Join Date: Feb 2006
Location: ny
Posts: 21
Likes: 0
Received 0 Likes
on
0 Posts
i need help please
a few month back my interior wire harness caught on fire due to a water leak in my trunk. some how the remote wire that connected to one of the amps grounded out causing the remote wire to burn from the trunk down the right side of the car ,and under the dash it went all the wy to the fuse box in the engine bay.i was wondering do any body have the diagram to remove the dash so i can finish fixing the harness ,i only have about a 20 inch section left to repair,i repaired the fuse box wires and the wires going from the rear of the vehicle to the front.i know i can just jump the wire from the fuse box to the part that i fixed ,but i just want to make sure that no other wire are melted together ,thanks if anybody can help me
10-01-07, 02:37 PM
#3
Lexus Champion
a few month back my interior wire harness caught on fire due to a water leak in my trunk. some how the remote wire that connected to one of the amps grounded out causing the remote wire to burn from the trunk down the right side of the car ,and under the dash it went all the wy to the fuse box in the engine bay.i was wondering do any body have the diagram to remove the dash so i can finish fixing the harness ,i only have about a 20 inch section left to repair,i repaired the fuse box wires and the wires going from the rear of the vehicle to the front.i know i can just jump the wire from the fuse box to the part that i fixed ,but i just want to make sure that no other wire are melted together ,thanks if anybody can help me
Thread
Thread Starter
Forum
Replies
Last Post
margarita
LS - 1st and 2nd Gen (1990-2000)
0
04-20-12 01:16 PM
littorose
Lexus Audio, Video, Security & Electronics
6
04-29-08 12:47 AM