OK, All set w/SRT vacuum hoses - last wiring question and I'm ready to go!
#1
Driver
Thread Starter
Join Date: Jan 2006
Location: MA
Posts: 129
Likes: 0
Received 0 Likes
on
0 Posts
OK, All set w/SRT vacuum hoses - last wiring question and I'm ready to go!
I have the intake installed, the cover on and the wiring done to the last wire, but the instructions show that Sensor 2 is a Black wire. When I look at my harness, in the location specified, the wire is Black/Yellow (see cheesy diagram below). There is a Black wire to the left, but not where the instructions specify.
Should I connect to the Black/Yellow wire (believing that the LOCATION in the directions is correct) or the Black wire (believing that the COLOR in the directions is correct)?
Once I get this completed, I'm ready to crank!
This picture shows the right-most connector and wires in the ECU, and only the upper right portion of this block:
╔═╦═╦
╚═╩═╩ <--instructions are blank for this top row
╔═╦═╦═╦═╦ <--instructions show; blank, sensor 2 (BLACK), blank, blank
╚═╩═╩═╩═╩ <--actual wires are; BLACK, BLACK/YELLOW, whatever, whatever
Thanks again in advance,
David
781-771-3636
Should I connect to the Black/Yellow wire (believing that the LOCATION in the directions is correct) or the Black wire (believing that the COLOR in the directions is correct)?
Once I get this completed, I'm ready to crank!
This picture shows the right-most connector and wires in the ECU, and only the upper right portion of this block:
╔═╦═╦
╚═╩═╩ <--instructions are blank for this top row
╔═╦═╦═╦═╦ <--instructions show; blank, sensor 2 (BLACK), blank, blank
╚═╩═╩═╩═╩ <--actual wires are; BLACK, BLACK/YELLOW, whatever, whatever
Thanks again in advance,
David
781-771-3636
Thread
Thread Starter
Forum
Replies
Last Post
TakaM
LS - 1st and 2nd Gen (1990-2000)
4
11-05-17 04:57 PM