ls430 retro..thanks JnC
#16
Intermediate
Thread Starter
Join Date: Feb 2007
Location: SO*CAL
Posts: 334
Likes: 0
Received 0 Likes
on
0 Posts
BAD NEWS
when i started adjusting the lights with the screwdriver, i stripped the plastic adjustment tabs on the inside, BOTH SIDES!!(I SCREWED THEM IN/OUT TOO HARD)
at least i know what was the cause of this....i did not trim enough of the bezel and the bottom of the projector shroud caught it and it went downhill from there
when i started adjusting the lights with the screwdriver, i stripped the plastic adjustment tabs on the inside, BOTH SIDES!!(I SCREWED THEM IN/OUT TOO HARD)
at least i know what was the cause of this....i did not trim enough of the bezel and the bottom of the projector shroud caught it and it went downhill from there
#17
Driver
iTrader: (4)
Join Date: Oct 2007
Location: Ohio
Posts: 132
Likes: 0
Received 0 Likes
on
0 Posts
BAD NEWS
when i started adjusting the lights with the screwdriver, i stripped the plastic adjustment tabs on the inside, BOTH SIDES!!(I SCREWED THEM IN/OUT TOO HARD)
at least i know what was the cause of this....i did not trim enough of the bezel and the bottom of the projector shroud caught it and it went downhill from there
when i started adjusting the lights with the screwdriver, i stripped the plastic adjustment tabs on the inside, BOTH SIDES!!(I SCREWED THEM IN/OUT TOO HARD)
at least i know what was the cause of this....i did not trim enough of the bezel and the bottom of the projector shroud caught it and it went downhill from there
#18
Intermediate
iTrader: (3)
Uh oh, need not worry, just open the headlights again, replace the adjustment *****, trim the bezel and seal them back together .
I told you to shave the inside of the factory GS bezel before you install.
here is a picture to show you how it needs to be trimmed.
Also let me know if you need the *****, i might have 1 or 2 in the bin, might.
I told you to shave the inside of the factory GS bezel before you install.
here is a picture to show you how it needs to be trimmed.
Also let me know if you need the *****, i might have 1 or 2 in the bin, might.
Thread
Thread Starter
Forum
Replies
Last Post