Carter300

My question is with all the fuss about how much everyone hates Leds and all this...why cant you take off the red/clean housing from the poicture above...and put it on the 01+ back housing?...is it a fitment issue or something?? Or am i jus a big gimmick....plz lemme kno...

TYPEII

iTrader: (5)

I would almost want to do the opposite, take the OEM 01+ outer with the orange and swap those on the LED ones...

TYPEII

iTrader: (5)

Not hard at all, be like taking the 98-00 and doing the clearing Mod. All you need is time, patience, a Dremel and some silicone.

Be the best of both world, you'll end up with OEM LED and a set that would be 98% close to the JP OEMs...

DaveGS4

iTrader: (2)

The 01+ tails can not be cleared like the 98 - 00 tails... it's a totally different design and many folks runed tail lights trying when they first came out.

The idea of taking the entire plastic face off of a LED set and putting it on an OEM 01+ light is interesting though. You could probably put the OEM plastic face with the orange stripback on the LED set and sell it on ebay and recoup your costs.

I've never looked at how that entire piece is attached around the edges though.

Search please louie . Use advanced search on the 2GS forum and keywords like clear tail or clear dremel.

TYPEII

iTrader: (5)

What I meant to say was, that the steps would be the same. You would have to dremel open the halves...

VNN326

iTrader: (21)

you should make OEM LED Tails. and Fake JP ONES !!! whooooooo!

taeng

iTrader: (1)

I would think OEM covers on the LED tails would almost be thinking backwards...I would think most people want the clear signal over the orange. It would be interesting to see though

99GS4

I would like to see someone attempt this... I wouldn't mind trying but I don't like to gamble.