sam430

iTrader: (10)

I've been searching everywhere to that special 12.9 bolts for my front custom RCA. I've finally found the place that sells all kinds of bolts and doesn't have to be bought in the 10's of thousands.

http://www.u-neacfasteners.com/products.html

All I need to know is how long of a bolt I need for the M12x1.25 bolt at 12.9 grade. Anyone? Save me from jacking up the car. the offset is +3/4 inches.

GSteg

iTrader: (15)

I'll measure when I get home in an hour

chrispy

iTrader: (21)

Henry, does Hillco have them?

GSteg

iTrader: (15)

Hilco does have them. that where I bought mine.

sam430

iTrader: (10)

THANKS! LS400 brakes!

GSteg

iTrader: (15)

The OEM bolt is 1.365" long, and that's excluding the socket head itself. Obviously the length of the head doesn't matter

sam430

iTrader: (10)

Thanks again.

1.365 + 3/4 = 53.72100 millimeters

edit: had to buy from Hilco.

GSteg

iTrader: (15)

sounds about right. I think mine were about 45mm-ish. Then again i have 1/2" RCAs.

sam430

iTrader: (10)

one thing for sure is..it's very expensive. about 7 bux a bolt... I don't even know bout the shipping cost. I said just send it. Been waiting too long can't wait. LOL.

I ended up getting 60mm I guess it'll stick out.

GSteg

iTrader: (15)

Only one bolt will stick out through the knuckle. The other bolt has its limitation on how far you can bolt it in. Add washers though.

$7/bolt is a lot of money. I bought mine for maybe $1/bolt. Then again, who knows they might be sending you some ARP bolts

kit cat

iTrader: (6)

i hope you didn't quote me on the M12x1.25...that was off my memory from 6months ago.

sam430

iTrader: (10)

LOL... no problem. I did ask EXACT and GSteg... so they are on the hook too ARP bolts? hmmm.... I wonder if I can cut it. I may just use washers though...

AHHH ARP (Automotive Racing Product)... the sales lady said "wow! these must be some rare bolts! they are expensive"

After all this, I may ditch it and get the EXACT version. It depends on how much of a drop I want.

GSteg

iTrader: (15)

I added a washer to mine because the bolts I bought are not flanged like the OEM bolt. Obviously you don't want to go on a washer-spree and add 4

sam430

iTrader: (10)

Hmm...I can maybe add the washer to give me close to 1 inch...but then again, I loose the flange like support. I doubt mine will come with a flange..it's hex.




Oh...I'm not sure I'm going to replace with this new lower ball joint. I don't think the ones currently on my gs is exposed like this one. BTW, haven't done it before but the is my prejudgement of the system.

sakataj

iTrader: (182)

ok stop doing the rca's and get a better camera first or atleast zoom out my friend