98 GS400 Fog lights
02-09-09, 10:04 PM
#31
Driver School Candidate
Join Date: Apr 2008
Location: California
Posts: 46
Likes: 0
Received 0 Likes
on
0 Posts
I had the same problem with my GS400. I think i have the answer! The headlight switch which is also your blinker selector gets loose and you need to push it back towards the steering wheel. I noticed this, after i make a turn with my signal back to center the signal lever flies back into its normal position. When it goes back it pulls the fog light switch away from the steering wheel. All you need to do in make sure the lever is pushed towards the steering wheel tightly.
02-10-09, 10:42 AM
#33
Are you running 2 sets of HID in your ride? If so, then it's probably lack of sufficient power to 4 HID ballast. You might want to get a HID harness for the foglights then. It's funny that on the 98 GS you can just plug and play HIDs to headlights and foglights and they'll work but on the 02 GS3 you can't just plug and play, I tried to run HIDs for head & foglights but fogs won't turn on. Some say get a harness and some say, just reverse the plug and it'll work (No thank you to this way because i won't want to fry any electrical in my GS)
VIP-209- I have/had the same problem that you're having. Both foglights won't turn on but if i tap on it then it turns out. So I took off my foglights and unplugged the bulb and found out that part of my connector was burnt/melted and that the metal pins on the 9006 bulb were corroded/rusted. So what i did was got a little file and sanded the rust off and plugged it back it and it's working now. I will be getting a Harness though for the fog when I install HIDs for the fog.
im just gonna get these http://www.mobilehid.com/support.htm
Thread
Thread Starter
Forum
Replies
Last Post
