sleeper408

iTrader: (6)

So are the fender liners there only for cosmetic purposes then? Such as hiding the sheet metal in the wheel well? Nice work with the hole saw. I used that once with a drill press and took me forever to cut out some metal.

Debonair

Nice work. Ride low at any costs huh. It should be real easy to patch that up with anything from some sheet metal to a simple piece of vinyl decal.

4play4dr

i guess the way i got it done is really extreme compared to these simple hole ones..i still gotta finish mine up

LEXUS_KID

iTrader: (4)

Looks good

GS300Rich

nicely done

shern

iTrader: (6)

I used to do this all the time with my Hondas back in the day. Throw a little gorilla tape over that hole.

Emil

very brave i tell you!!

VIS250P

iTrader: (1)

Oh yeah he got ***** to do it...

veritek

There you go, that's the way you should have done it, heheh. Ride around town for a little bit, and the marks would have been made for you!! Good job tho, took a lot of guts!!

sakataj

iTrader: (182)

will look better if he get some sheet metal and patches it all up but otherwise its cool and works

Rich27

iTrader: (9)

I need to this too. Good job!

Rich27

iTrader: (9)

How hard was the job?

What where the risks involved?

GSteg

iTrader: (15)

Drilling itself isn't hard. It's not rocket science, but at the same time, you want to drill the hole ONCE and only ONCE. Wouldn't want to be off by a few inches and have to drill another hole again

kit cat

iTrader: (6)

i've always wanted to do this but two things that scared me...

1) rain, dirt, and grime. I guess I could somehow glue on the fender liner and extend it a bit and weld on a cylinder of some sort on top...

2) structural rigidity and long term stress. anyone?

Finding the hole shouldn't be too hard for us who sit low enough...the damn upper control arm made a mark on my liner that screams "CUT HOLE HERE"

carbongs

iTrader: (13)

nice i will be doing this in a few weeks when my air ride gets in