Rubber Door Molding
#1
Pole Position
Thread Starter
Join Date: Jan 2009
Location: NYC
Posts: 287
Likes: 0
Received 0 Likes
on
0 Posts
#7
Pole Position
Thread Starter
Join Date: Jan 2009
Location: NYC
Posts: 287
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://www.clublexus.com/forums/images/icons/icon1.gif)
has it held up so far?
so it is a seperste peice than the whole panel
my body guy told me it wasnt...how bad was it to replace?
![Thumb Up](https://www.clublexus.com/forums/images/smilies/thumbsup.gif)
Trending Topics
#8
![Default](https://www.clublexus.com/forums/images/icons/icon1.gif)
After removing the interior panel. That bottom outter part is held on by three black ***** that you can just screw off with a 10mm or so. Then you remove the outter panel, you would have to pry it off of clips, some adesive and a sticky foam piece. Then remove about 6 screws that position the molding and and slide out the old and in with the new. It cost about $27 from sewelllexusparts.com. I had replaced the Millemium Silver 199 moulding with a new one, and the paint it barely noticable. My car see no sun because I'm in Seattle, so the paint matched well.
#9
Lexus Champion
![Default](https://www.clublexus.com/forums/images/icons/icon1.gif)
not to steal your thread or anything but im in need of parts too. and i dont want to make a new thread about it when theres this one already, so
![](http://i39.tinypic.com/b968ec.jpg)
anyone know if i can get those blue areas from lexus also?
thx, sorry for bothering the OP by asking my own questions.
![](http://i39.tinypic.com/b968ec.jpg)
anyone know if i can get those blue areas from lexus also?
thx, sorry for bothering the OP by asking my own questions.
#11
Pole Position
Thread Starter
Join Date: Jan 2009
Location: NYC
Posts: 287
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://www.clublexus.com/forums/images/icons/icon1.gif)
![Argue](https://www.clublexus.com/forums/images/smilies/argue.gif)
J/K LMAO
![Stick Out Tongue](https://www.clublexus.com/forums/images/smilies/tongue.gif)
Thread
Thread Starter
Forum
Replies
Last Post
ziggyziggy
RX - 3rd Gen (2010-2015)
10
10-19-12 08:06 PM
ojah
LS - 4th Gen (2007-2017)
4
12-18-07 08:57 AM