kit cat

iTrader: (6)

Those little holes near the hub on the rotor to put in a small bolt to push the rotor off, is that a M8x1.25??


^pic of a TL I found from google.

GSteg

iTrader: (15)

I think they were M10x1.25 the last time I took off my rotors. It may vary from brand to brand though.

vwynn

iTrader: (4)

last time that i didnt have the bolt on hand.. i just sprayed WD-40 in the 2 screw holes and took my rubber mallet to it.

kit cat

iTrader: (6)

i was afraid of that. I really don't want to have to deal with friggin R1 Concepts customer service again. I may just buy M6, M8, M10, M12 x 1.25 and see which one fits

Errr...I'd rather not beat it with a mallet if I can screw a bolt in and pop out. If I have to resort to this, I will though

skperformance

iTrader: (6)

One of the caliper screws from the front or rear should fit it.

1sikgs

definitely m8x1.25

timgs300

iTrader: (22)

Small - Medium ball peen hammer. Wail away - alternate opposite sides. Never had a problem with that.

sakataj

iTrader: (182)

coco.....look at posts 8-9
https://www.clublexus.com/forums/gs-...ml#post4833014

JeffTsai

iTrader: (1)

I'll go double check if anyone needs, but just goto your local hardware store and pick up an assortment of metric bolts. It doesn't cost much and its good to have a few extra ones laying around anyways.

JiBBeL

iTrader: (2)

Same here. This is what I've always done.