View Poll Results: Are you interested in clear lense for the stock fog lights?
Voters: 118. You may not vote on this poll
Fog Light Modifications Lense
04-04-11, 01:27 PM
#136
This would be a good start to rip them apart and install a projector. Half the work is done.
Not feeling the LED stip but great for parts......
http://cgi.ebay.com/ebaymotors/98-99...item588d56a24f
Not feeling the LED stip but great for parts......
http://cgi.ebay.com/ebaymotors/98-99...item588d56a24f
05-04-11, 12:21 PM
#139
I may look into a clear lense locally... hope it's not too costly. I'll let you guys know if I go through with it.
edit: FAIL... they said that they can't do it. Loser. I'm gonna do it. It won't be pretty unless I want to go ahead and make a mold.
edit: FAIL... they said that they can't do it. Loser. I'm gonna do it. It won't be pretty unless I want to go ahead and make a mold.
Last edited by sam430; 05-04-11 at 04:18 PM.
05-04-11, 04:24 PM
#140
This is the method I'd like to apply. Preheat the oven to the point where the polycarbonate starts to losen up or form to the contour of the mold.... then put it into another preheat oven at 300 or so degree to prevent oxygen soak or whatever it's called (to preven bubbles).
http://www.palram.com/htmls/article....3362&bsp=12984
but I will do quick and dirty flat piece.
http://www.palram.com/htmls/article....3362&bsp=12984
but I will do quick and dirty flat piece.
Thread
Thread Starter
Forum
Replies
Last Post
bigwasum
2Gen GS430 / 400/ 300 Classifieds (98-05)
5
05-24-12 01:18 PM
SC3coupe
IS - 2nd Gen (2006-2013)
8
07-20-07 11:27 AM
