GS4_Fiend

iTrader: (22)

Your front camber is bad and rear toe is no bueno

excluesive

iTrader: (10)

i only had toe problems when i started driving at the lip of my rims AKA floor to quarter heigh of about 21"

sam430

iTrader: (10)

Sell your RCA and go with FIGS parts. If you have the newer coilovers, you can adjust height without affecting shock travel. The only reason, I can think of for having rca, is you want to install LS400 brakes -even then you can shave the crown of the bolt.

Sell both the front and rear rca and get the mega arm.

of, if you are not ready for fig's arm, go with the spc.

TruPlaya26

iTrader: (4)

Does figz sell front arms as well as rear?

sam430

iTrader: (10)

You would have to check with what he currently have. Also, from the look of the rear RCA setting, you are adding more negative camber. I think it should be flipped the other way. PM him.

double check with those who already have it installed (rear RCA).

Well, I remember the RCA was suppose to help with the LBJ too but I don't know for sure.

GSteg

iTrader: (15)

There is a reason to keep the RCAs, at least the front ones, and that's for roll center correction. Your end roll center may not be as good as stock, but it's sure better than not having RCAs. You trade off one thing for another.

GS300ToM

iTrader: (32)

with the rear RCA... u cannot add neg camber from my experience thus adding only... as for your front idk whats wrong with it really lol get the spc UCA and you will be fine... but the lower u go the more neg camber u will get naturally for your front.. just worry about that as for now and get those adjustable TOE arms ASAP for your rears since u got new tires cause u can chew those in less than a month or two

PHML

iTrader: (33)

Front camber...you look more lower now than before after RCA installed...that's why your front camber is more NEGATIVE now. Raise your coilovers up to get them more positive...the other alternative is adjustable upper control arms if you want to roll that low. Front RCAs help with lessen stress to your LBJs and corrects overall susp. geometry.

Rear camber...your current insert setting only provides minimal positive camber. You need to flip that insert setting around....so the insert hole is closer to your coilovers/shocks...that will give you the most positive camber correction....+3 degrees...according to EXACT, right?

Right now...your pics show the insert holes are closer to the rotors/wheels...that only provides minimal positive camber correction....and thats why you are still at -3 degrees camber. Plus, like the front RCA...you drop down a bit on the rear RCAs. If you did NOT raise your coilovers back up....you will not gain any meaningful positive camber.

Most ppl running rear RCAs need adjustable toe arms. So far, megans adjustable toe arms for the IS300 have been used...they go for ~ $155 on ebay. FIGS (authorized CL Vendor) just made a set without welds...PM him directly.