How To Replace Side Marker Lights???
#1
Rookie
Thread Starter
How To Replace Side Marker Lights???
CAN ANYONE PLEASE TELL ME HOW TO DO THIS? SEND ME A PM. I HAVE CLEAR CORNER LIGHTS OR SIDE MARKER LIGHTS, AND DON'T KNOW HOW TO REMOVE THEM. HELP!!!!!
The following users liked this post:
Tilksh (11-11-19)
#2
there should be a screw next to the wheel to pull out the mud guard then you use a wrench to unscrew the sidemarker kinda blindside when u do it cause u can't see it just feel it only.
The following users liked this post:
kdrisk (03-07-20)
#3
just got done. You will need a 10mm socket (1/4" size) I used the smallest because it is tight. Remove the 10mm/phillips nut at the front of the wheel well ( about 13"-15" up). You can also remove the bottom screw if you have big hands. Bend nack the wheel well to get you hand inside; there are 2 10mm nuts to remove losen w/ wrench then I just spun them off with my fingers and socket. EASY and FAST.
#4
Lexus Test Driver
iTrader: (8)
Join Date: Feb 2002
Location: Texas
Posts: 898
Likes: 0
Received 0 Likes
on
0 Posts
Good pics, but sketchy directions
Try this linkhttp://www.angelfire.com/dc/bananags...ide/index.html
Use the 10mm wrench. The plastic fenderwell moves pretty easy. A deep socket ratchet would be the fastest, but didn't take long doing it by hand. Hope this helps. PM me if I can be of more help.
Blanco
Use the 10mm wrench. The plastic fenderwell moves pretty easy. A deep socket ratchet would be the fastest, but didn't take long doing it by hand. Hope this helps. PM me if I can be of more help.
Blanco
Last edited by Blanco; 07-06-02 at 07:59 PM.
#5
Lexus Fanatic
iTrader: (20)
Someone on another thread said it's easier just to take the fog light out and reach in.
The following users liked this post:
Tilksh (11-11-19)
Trending Topics
#10
Pole Position
Join Date: May 2002
Location: California
Posts: 286
Likes: 0
Received 0 Likes
on
0 Posts
Going through the foglight was a breeze. Remember not to touch the bulb directly or get any type of oil or dirt on it or it will burn out. AND also check to see that the light isn't burnt out before closing up shop and tightening all the screws! Just a bit of advice from someone who had to do all that.
BTW I replaced the stock bulbs with white ones that match the HIDs. Looks great IMO.
BTW I replaced the stock bulbs with white ones that match the HIDs. Looks great IMO.
#12
Lexus Champion
iTrader: (8)
Join Date: May 2001
Location: So Cal
Posts: 1,952
Likes: 0
Received 0 Likes
on
0 Posts
Sidemarkers
Well these you need not worry about touching directly. They are not like the 9006 bulbs that are used for the fogs/headlights. I carried my piaa wedge bulbs in my pocket for a week before I finally got around to installing them them. However..... I decided to go back to the stocks.
NE1 want to buy them?????? I will sell them.
Rock.
NE1 want to buy them?????? I will sell them.
Rock.
Thread
Thread Starter
Forum
Replies
Last Post