Can you fit BMW rims on a GS300 without any modifications?
07-06-11, 07:26 AM
#16
★ I
Thread Starter
Join Date: Jan 2009
Location: Ohio
Posts: 570
Likes: 0
Received 0 Likes
on
0 Posts
okay nicee that honeslty helps me so much hah so if i threw the 19mm spacer adapters on my car (No redrilling right?) with the VMR rims everything would work out right?
07-07-11, 04:43 PM
#21
Lexus Champion
07-07-11, 05:34 PM
#23
I rolled the rears and probably ended up pulling them slightly.
Fronts i just rolled real half assed.
Tires are 225/35 front, 245/35 rear.
Alignment has a good bit of camber in the rear but I should have more then enough room to dial it back out a lot.
I'm sure you could easily cut the rears and just mildly roll the fronts and be good with those tire sizes. The wheels without adapter spacers are only 19x9 and 19x10 +24 iirc, so its not too aggressive for a stock body GS.
Fronts i just rolled real half assed.
Tires are 225/35 front, 245/35 rear.
Alignment has a good bit of camber in the rear but I should have more then enough room to dial it back out a lot.
I'm sure you could easily cut the rears and just mildly roll the fronts and be good with those tire sizes. The wheels without adapter spacers are only 19x9 and 19x10 +24 iirc, so its not too aggressive for a stock body GS.
07-08-11, 08:16 PM
#29
Pole Position
iTrader: (7)
Join Date: Feb 2007
Location: Tx
Posts: 2,265
Likes: 0
Received 0 Likes
on
0 Posts
i got mine from motorsport technoologies.. they built 19 mm adapters for me works like a charm. But my fender mods were just a roll up front and a shave and a pull in the back. The tires are 215/35/19 up front and a 235/35/19 out back. i got to say i was scared to run that stretch but it was on point and it worked like a charm! here is a rolling shot of the car.
