Hand brake conversion options (no hydraulic)
#1
![Default](https://www.clublexus.com/forums/images/icons/icon1.gif)
Are there any parts from another vehicle that can be installed that looks clean? Im more focused on the interior part of this right now(rear caliper/drum/cables ill worry about later). So as far as center console, boot and the actual handle itself. Has anybody done or seen a clean install?
Again not looking for a hydraulic setup.
Again not looking for a hydraulic setup.
#3
Driver School Candidate
![Default](https://www.clublexus.com/forums/images/icons/icon1.gif)
seeing as the gs never came manual. there is most likely no option for a cable ebrake setup. your best bet is going to be a hydro setup. if you trying to have it as apart of th center console then you will have to do some sort of custom center console
#4
![Default](https://www.clublexus.com/forums/images/icons/icon1.gif)
If you look on Yahoo Auctions Japan you will see a few people advertise a service from what it looks like to do this on 5spd swapped cars.
It appears they use an SC/Soarer handbrake assembly, weld 2 brackets on the trans tunnel to mount it, then pull the center console off, weld a small base in there to mount the cables, and then run it to the handbrake.
![](http://img.photobucket.com/albums/v715/Prok0/handbrake_zps708b7645.jpg)
![](http://img.photobucket.com/albums/v715/Prok0/handbrake2_zps446683f5.jpg)
![](http://img.photobucket.com/albums/v715/Prok0/handbrake3_zps2411ea51.jpg)
![](http://img.photobucket.com/albums/v715/Prok0/handbrake4_zpsa9629890.jpg)
http://minkara.carview.co.jp/en/userid/883466/blog/p3/
It appears they use an SC/Soarer handbrake assembly, weld 2 brackets on the trans tunnel to mount it, then pull the center console off, weld a small base in there to mount the cables, and then run it to the handbrake.
![](http://img.photobucket.com/albums/v715/Prok0/handbrake_zps708b7645.jpg)
![](http://img.photobucket.com/albums/v715/Prok0/handbrake2_zps446683f5.jpg)
![](http://img.photobucket.com/albums/v715/Prok0/handbrake3_zps2411ea51.jpg)
![](http://img.photobucket.com/albums/v715/Prok0/handbrake4_zpsa9629890.jpg)
http://minkara.carview.co.jp/en/userid/883466/blog/p3/
Last edited by AKS14; 06-14-13 at 10:33 AM.
#5
Driver School Candidate
#6
![Default](https://www.clublexus.com/forums/images/icons/icon1.gif)
Are there any parts from another vehicle that can be installed that looks clean? Im more focused on the interior part of this right now(rear caliper/drum/cables ill worry about later). So as far as center console, boot and the actual handle itself. Has anybody done or seen a clean install?
Again not looking for a hydraulic setup.
Again not looking for a hydraulic setup.
#7
Driver
![Default](https://www.clublexus.com/forums/images/icons/icon1.gif)
Hopefully they will make something bolt in for the Aristo too, I see they already have a clutch pedal kit for both GS and Aristo
Thread
Thread Starter
Forum
Replies
Last Post