Anyone remove there exhaust manifold
#17
Pole Position
Here's a technicians note: Bank 2 sensor 1, 2 HINT:
-Before installing oxygen sensor, twist sensor wire COUNTER clockwise 3 and a half turns.
- After installing oxygen sensor, check that sensor wire is NOT twisted. If it is twisted, must remove the sensor and reinstall it.
Don't know if that applys to you but maybe it's twisted hence why it's still bringing up the code? Hence why they put this Technicians side note?
-Before installing oxygen sensor, twist sensor wire COUNTER clockwise 3 and a half turns.
- After installing oxygen sensor, check that sensor wire is NOT twisted. If it is twisted, must remove the sensor and reinstall it.
Don't know if that applys to you but maybe it's twisted hence why it's still bringing up the code? Hence why they put this Technicians side note?
Thread
Thread Starter
Forum
Replies
Last Post
Losiracer2
LS - 1st and 2nd Gen (1990-2000)
8
04-15-17 10:52 PM