devnull77

My passenger cooling servo isn't working and is stuck on cold air, I know there are a ton of posts about repairing the servos, but the only posts I could find showing how to get to the cooling servo have photos that no longer load. I actually did this job 8 or 9 years ago, but I don't remember how I removed that white box that blocks your access. I found one screw on the bottom, but the box as a whole is still attached to something, and I tried breaking it apart with the tabs on the seams in the middle, but wasn't successful. Anyone know what to do from here?

Arussto

In my exp. You dont remove box. Instead you get the three screws holding servo to box.
and youtube still have some .
######

I stand corrected. Its the duct at the front of the box you seem to be asking about.

I think ot wiggles out. May have a screw or two holdind it on the outside.

kevin3344

The entire piece should come out. Move the harness so you can see better. Here is a photo with it removed (not my car):