"Check VSC" warning???
#16
Driver School Candidate
Join Date: Oct 2005
Location: PA
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://www.clublexus.com/forums/images/icons/icon1.gif)
I just posted my tale in this parallel thread. I fixed my gas cap VSC problem myself. You might find it useful. https://www.clublexus.com/forums/4062449-post8.html
![Sad](https://www.clublexus.com/forums/images/smilies/sad.gif)
#17
![Default](https://www.clublexus.com/forums/images/icons/icon1.gif)
Lol..... They SHOULD HAVE changed the gas cap with the car. Lexus of Orlando did the same for me. They seem to waive the diagnostics fee for me everytime, only charging for parts and labor.
Reading about you guys' symptoms, I think i'm blessed to have this dealership take care of me, especially for all these diagnostics fees.
Reading about you guys' symptoms, I think i'm blessed to have this dealership take care of me, especially for all these diagnostics fees.
#19
Driver School Candidate
Join Date: Jan 2018
Location: ca
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
![Default](https://www.clublexus.com/forums/images/icons/icon1.gif)
I have a 2008 LS460 and in the past 2 months, I've seen the Check VSC system message appear on occasion. I took it to two different mechanics. The first one helped me with a new battery. A few weeks after I initially received the VSC message, my battery died. I believe that the VSC system could have been related to the battery. If you are having issues, I would start here and take it to the mechanic and have them test the battery life.
However, after I replaced the battery, within a week, the dreaded VSC system message appeared again. I had a different mechanic look at it, and they said the code readings are fine, but they did find that the clamp around the induction hose was loose. Since the VSC reads mass air flow, the loose clamp could have triggered the sensor and caused the VSC message. The fix: they tightened the clamp, changed the filter, and said all looked good. Total cost for all this was $150.00.
I'll send an update if that didn't resolve the VSC message, but I think that this tightening of the clamp should take care of it.
However, after I replaced the battery, within a week, the dreaded VSC system message appeared again. I had a different mechanic look at it, and they said the code readings are fine, but they did find that the clamp around the induction hose was loose. Since the VSC reads mass air flow, the loose clamp could have triggered the sensor and caused the VSC message. The fix: they tightened the clamp, changed the filter, and said all looked good. Total cost for all this was $150.00.
I'll send an update if that didn't resolve the VSC message, but I think that this tightening of the clamp should take care of it.
Thread
Thread Starter
Forum
Replies
Last Post
ApoK
IS - 2nd Gen (2006-2013)
3
11-26-08 10:32 AM