noob question. screw for rear license plate missing.
04-22-09, 04:23 PM
#1
Driver School Candidate
Thread Starter
Join Date: Jan 2006
Location: ca
Posts: 18
Likes: 0
Received 0 Likes
on
0 Posts
noob question. screw for rear license plate missing.
hey folks, i havent been on this site forever, but recently one of the screws on my rear license plate just disappeared so my plate is hanging by one screw. i tried to find a screw for this but all of them are two short?? does anyone know the size or wear i can get this screw?? sorry for the noob question.
04-22-09, 09:02 PM
#4
make sure you get stainless steel or nylon (they won't rust).
you can also take the one remaining screw out at autozone or some other major auto parts store. They will have a variety of screw sets to choose from. Just match your current one up for length.
steviej
you can also take the one remaining screw out at autozone or some other major auto parts store. They will have a variety of screw sets to choose from. Just match your current one up for length.
steviej
Last edited by steviej; 04-26-09 at 01:08 PM.
04-22-09, 09:40 PM
#5
Intermediate
I had to do a similar thing when I installed my front plate... the bracket kit didn't have screws in it to actually screw the plate to the bracket once the bracket is installed on the bumper. I took the plate bracket to Home Depot but couldn't find the right screw.... then I went over to Lowe's and found them there at the right length too.
Thread
Thread Starter
Forum
Replies
Last Post
