Full Custom Dual setup in progress!
#16
looking good Rider! Can't wait to see/hear the vid. The next to the last bend to the mufflers seems a bit low. I hope they won't scrape the grounds over bumps. Also, that's a long running pipe without any support. Do you have any concerns with that in the long run? Looking hot otherwise, congrats!
#18
Lexus Fanatic
iTrader: (33)
welcome to the club surprised more haven't done this yet. post up some youtube videos as Im curious how it sounds on the 460 vs the 430 I used to own.
also did they move your primary o2 sensors further back? looks like they capped the original bungs and moved then further back. My old car, US spec, had 3 total.
also did they move your primary o2 sensors further back? looks like they capped the original bungs and moved then further back. My old car, US spec, had 3 total.
#19
Thread Starter
Lexus Test Driver
Joined: Aug 2009
Posts: 924
Likes: 0
Received 0 Likes
on
0 Posts
From: Middle East
welcome to the club surprised more haven't done this yet. post up some youtube videos as Im curious how it sounds on the 460 vs the 430 I used to own.
also did they move your primary o2 sensors further back? looks like they capped the original bungs and moved then further back. My old car, US spec, had 3 total.
also did they move your primary o2 sensors further back? looks like they capped the original bungs and moved then further back. My old car, US spec, had 3 total.
#26
i came across this video on youtube
comparison on ISF between Borla with stock manifold and Borla cat back with Sikky headers
totaly lovin the sikky headers note..
check it out
http://youtu.be/Wavz7h5Wj5k
HOW to EMBED this vid????
comparison on ISF between Borla with stock manifold and Borla cat back with Sikky headers
totaly lovin the sikky headers note..
check it out
http://youtu.be/Wavz7h5Wj5k
HOW to EMBED this vid????
Last edited by imadesign; 05-04-12 at 06:22 AM.
Thread
Thread Starter
Forum
Replies
Last Post
Dx3
2Gen GS430 / 400/ 300 Classifieds (98-05)
15
07-18-06 12:46 PM