Installed New Reverse Lights with Steps
10-15-14 | 12:40 AM
#1
Installed New Reverse Lights with Steps
So I decided to upgrade my reverse lights with some Putco Plasma LED bulbs. The size is 921 if anyone wants to replace them.
The box:
The bulbs:
Pop open the trunk and take off the 3 corner tabs holding the lining in. I used a screwdriver to pull up and loosen the tabs. Once you can fit your fingers under the lining, just pull towards your body(takes a decent amount of leverage and force)
This is the connector to your reverse light. Just turn counter-clockwise, pull it out and replace the bulb.
Installed pics!
Bonus pic of my tinted tail lights.
This is like a 2/10 on a difficulty scale for DIY. I was looking up pics on the 3GS Faqs page and I believe the link for replacing all the lights don't have the pics anymore so thought I'd share.
Thanks for looking 3GS fam!
The box:
The bulbs:
Pop open the trunk and take off the 3 corner tabs holding the lining in. I used a screwdriver to pull up and loosen the tabs. Once you can fit your fingers under the lining, just pull towards your body(takes a decent amount of leverage and force)
This is the connector to your reverse light. Just turn counter-clockwise, pull it out and replace the bulb.
Installed pics!
Bonus pic of my tinted tail lights.
This is like a 2/10 on a difficulty scale for DIY. I was looking up pics on the 3GS Faqs page and I believe the link for replacing all the lights don't have the pics anymore so thought I'd share.
Thanks for looking 3GS fam!
Thread
Thread Starter
Forum
Replies
Last Post
joelgs3
GS - 1st Gen (1993-1997)
10
07-01-07 05:38 PM
Baby ///M3
SC- 1st Gen (1992-2000)
7
07-24-03 11:42 PM