How to change lights for 2006 GS300
#1
Driver School Candidate
Thread Starter
Join Date: Nov 2016
Location: WA
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
How to change lights for 2006 GS300
Hello genius
I'm new here. found this awesome forum recently.
Just wanna ask how to change lights for 2006 GS300. (It's a used car and lights are getting somber and gloomy).
I wanna change lights to WHITE LEDs. (4 door lights + 5 interior lights at front + 4 interior lights at rear + 1 in the trunk boot + 2 puddle lights + 2 license lights )
Here're photos I took just in case for any further references.
Does anyone know how to change them ???
Could you please tell me the name & models of WHITE LED lights???
I will get them on eBay.
Thanks in avdance.
I'm new here. found this awesome forum recently.
Just wanna ask how to change lights for 2006 GS300. (It's a used car and lights are getting somber and gloomy).
I wanna change lights to WHITE LEDs. (4 door lights + 5 interior lights at front + 4 interior lights at rear + 1 in the trunk boot + 2 puddle lights + 2 license lights )
Here're photos I took just in case for any further references.
Does anyone know how to change them ???
Could you please tell me the name & models of WHITE LED lights???
I will get them on eBay.
Thanks in avdance.
Last edited by Andy1206; 11-10-16 at 11:03 PM.
Trending Topics
#8
The following users liked this post:
2006GeeEss (03-08-18)
#10
I have also wanted to do this, so I took this apart yesterday
the smd leds are soldered directly to the board
I've come to the decision that it's not possible and I'm real good with a soldering iron😢
the smd leds are soldered directly to the board
I've come to the decision that it's not possible and I'm real good with a soldering iron😢
#11
QUOTE=sprtn131;10138064]I have also wanted to do this, so I took this apart yesterday
the smd leds are soldered directly to the board
I've come to the decision that it's not possible and I'm real good with a soldering iron😢[/QUOTE]
It looks like the boards may twist off. It's doable. You would need a really fine point tip to work on them.
the smd leds are soldered directly to the board
I've come to the decision that it's not possible and I'm real good with a soldering iron😢[/QUOTE]
It looks like the boards may twist off. It's doable. You would need a really fine point tip to work on them.
Thread
Thread Starter
Forum
Replies
Last Post