What did you do to your GS today?
#2611
@chinee love 303 too. I use that stuff on all my cars interior and engine bay. Helps protect from UV Rays. None of that nasty greasy shine either.
I didn't do anything on my cars today. But helped neighbor clay bar and wax his Taco. That poor thing has been neglected for so long. We brought the paint back to life.
I didn't do anything on my cars today. But helped neighbor clay bar and wax his Taco. That poor thing has been neglected for so long. We brought the paint back to life.
The following users liked this post:
RichardB23 (09-16-19)
The following users liked this post:
RichardB23 (09-16-19)
#2613
Pole Position
Hit it with some 303 inside and under the hood. Cleaned the windshield and interior glass surfaces, been about 6 months so it's been overdue. Used a diluted IPA solution to remove the oils and film, and Invisible Glass to shine. First time trying the IPA and Invisible Glass... fingers are crossed.
The following users liked this post:
bob256k (09-16-19)
#2614
Instructor
Awesome! I just got some 303, its great to hear (AND SEE) that you can use it practically anywhere on the car!
#2615
Pole Position
How are you guys washing the engine bay? Are you guys just spraying the product then hosing it off?
#2616
The following users liked this post:
RichardB23 (09-16-19)
#2617
Pole Position
#2618
Wait... I seem to remember dusty conditions? If so, go easy with any protectant you use, the dust can stick to it.
Good luck.
The following users liked this post:
RichardB23 (09-16-19)
The following users liked this post:
RichardB23 (09-18-19)
The following 2 users liked this post by charley95:
RichardB23 (09-18-19),
signdetres (09-18-19)
#2621
Racer
The following users liked this post:
RichardB23 (09-18-19)
The following users liked this post:
RichardB23 (09-20-19)
#2624
Pole Position
#2625
Lexus Test Driver
iTrader: (1)
I got a sheet of amber tint on eBay, it''s more orange than laminx so when you turn the light on it will be a deeper yellow.
So I applied the tint dry it's easier that way, took a couple tries to get it perfect without air bubbles.
Then I rough cut the tint on the lens(so I do have cut marks on the lens under everything.
Then I used electrical tape and wrapped the edge of the lens to make a perfect circle.
Used the electrical tape as a guide to cut the tint/tape in a near perfect circle. Removed the scrap tape/tint that I cut off.
Then put two layers of electrical tape(3m super sticky one) on the edges to hold the tint down and lock it in place.
Last edited by peasodos; 09-20-19 at 11:03 AM.
The following users liked this post:
soulless (09-20-19)