When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
From the way the fender piece is cut it looks exactly the way the 3M is cut on mine. The quality of the 3M is very poor on mine compared to the rest of the Xpel I have on the car.
From the way the fender piece is cut it looks exactly the way the 3M is cut on mine. The quality of the 3M is very poor on mine compared to the rest of the Xpel I have on the car.
Yeah. The 3M was on my wife's C70. When I got my RX done with XPel we compared her car to mine and changed it over. XPel has gone on all my vehicles and hers since then
I also have to get off my lazy butt and hardwire my dashcam as well. Got this almost 2 months ago and haven't found the will to go out in the heat and start messing with the overhead console. Question, how do you get the wire leads to remain in the connector?
I just forced them in, they will not move. The overhead console is tight. And also I recommend you use some wire loom cloth tape to wrap around the wires to help silence them when you go over bumps, and also secure everything tight. I didn't do that and need to open it back up to do that to get rid of a rattle when I go over hard bumps...
Installed new coils, GSF BBK front/rear, brembo rotors, power stop pads, new custom strut bar, new tires / repainted wheels, spark plugs, filters, oil change etc haha. It was a busy day for Danny @ HTL Motorsports but he did an amazing job!
Seems like the increased the prices since I first posted about this last year. Just pull up the the rubber and you can rotate the entire thing to shorten it to make the rubber stick out more for a tighter fit in the cup-holder.
IMO it's the cleanest looking and best phone holder for our car.
Thanks to MX5NES350... these hinge covers were just $10 and literally a snap to install. I'm probably the only person who will notice them, but definitely worth it...
Had plans to wash the ride early this morning before the sun came out strong, but the rain started and didn't stop until the afternoon. Broke out the bucket and hose at about 7:00 pm and went to work... pretty satisfying result.